--- zzzz-none-000/linux-2.6.32.61/fs/squashfs/Kconfig	2013-06-10 09:43:48.000000000 +0000
+++ ar10-7272-687/linux-2.6.32.61/fs/squashfs/Kconfig	2010-05-07 11:20:29.000000000 +0000
@@ -1,22 +1,20 @@
 config SQUASHFS
-	tristate "SquashFS 4.0 - Squashed file system support"
-	depends on BLOCK
+	tristate "SquashFS 3.4 - Squashed file system support"
 	select ZLIB_INFLATE
 	help
-	  Saying Y here includes support for SquashFS 4.0 (a Compressed
+	  Saying Y here includes support for SquashFS 3.4 (a Compressed
 	  Read-Only File System).  Squashfs is a highly compressed read-only
 	  filesystem for Linux.  It uses zlib compression to compress both
 	  files, inodes and directories.  Inodes in the system are very small
 	  and all blocks are packed to minimise data overhead. Block sizes
 	  greater than 4K are supported up to a maximum of 1 Mbytes (default
-	  block size 128K).  SquashFS 4.0 supports 64 bit filesystems and files
-	  (larger than 4GB), full uid/gid information, hard links and
-	  timestamps.  
+	  block size 128K).  SquashFS 3.3 supports 64 bit filesystems and files
+	  (larger than 4GB), full uid/gid information, hard links and timestamps.  
 
 	  Squashfs is intended for general read-only filesystem use, for
 	  archival use (i.e. in cases where a .tar.gz file may be used), and in
 	  embedded systems where low overhead is needed.  Further information
-	  and tools are available from http://squashfs.sourceforge.net.
+	  and filesystem tools are available from http://squashfs.sourceforge.net.
 
 	  If you want to compile this as a module ( = code which can be
 	  inserted in and removed from the running kernel whenever you want),
@@ -49,3 +47,4 @@
 
 	  Note there must be at least one cached fragment.  Anything
 	  much more than three will probably not make much difference.
+