#include <dt-bindings/interrupt-controller/arm-gic.h>
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/soc/bcm963xx_dt_bindings.h> 

#define GIC_DIST_BASE	0x81001000
#define GIC_CPUI_BASE	0x81002000

#define TIMER_HYP_PPI			10
#define TIMER_VIRT_PPI			11
#define TIMER_PHYS_SECURE_PPI		13
#define TIMER_PHYS_NONSECURE_PPI	14

#define PMU_CORE0_SPI			9
#define PMU_CORE1_SPI			10
#define SDIO_EMMC_SPI           95

#define DEVICE_TREE
#include "../../../shared/opensource/include/pmc/pmc_firmware_68560.h"
#undef DEVICE_TREE

/dts-v1/;

/memreserve/ 0x00000000 0x00020000;
/* For PMC3 firmware */
/memreserve/ PMC3_RESERVED_MEM_START PMC3_RESERVED_MEM_SIZE;

#include "../bcm_rsvdmem_64.dtsi"

/ {
    model = "Broadcom-v8A";
    compatible = "brcm,brcm-v8A";
    interrupt-parent = <&gic>;
    #address-cells = <2>;
    #size-cells = <2>;

	cpus {
		#address-cells = <2>;
		#size-cells = <0>;

		B53_0: cpu@0 {
			device_type = "cpu";
			compatible = "arm,cortex-a53";
			reg = <0x0 0x0>;
			next-level-cache = <&L2_0>;
		};
		B53_1: cpu@1 {
			device_type = "cpu";
			compatible = "arm,cortex-a53";
			reg = <0x0 0x1>;
#if defined (CONFIG_OPTEE)
			enable-method = "psci";
#else
			enable-method = "spin-table";
#endif
			cpu-release-addr = <0x0 0xfff8>;
			next-level-cache = <&L2_0>;
		};
		L2_0: l2-cache0 {
			compatible = "cache";
		};
	};

#if defined (CONFIG_OPTEE)
	psci {
		compatible	= "arm,psci-0.2";
		method		= "smc";
		cpu_off		= <1>;
		cpu_on		= <2>;
	};

	firmware {
		optee {
			compatible = "linaro,optee-tz";
			method = "smc";
		};
	};
#endif /* CONFIG_OPTEE */

	gic: interrupt-controller@81000000 {
		compatible = "arm,cortex-a15-gic", "arm,cortex-a9-gic";
		#interrupt-cells = <3>;
		#address-cells = <0>;
		interrupt-controller;
		reg = <0x0 GIC_DIST_BASE 0 0x1000>,
		      <0x0 GIC_CPUI_BASE 0 0x2000>;
	};

	timer {
		compatible = "arm,armv8-timer";
		interrupts = <GIC_PPI TIMER_PHYS_SECURE_PPI    (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
			     <GIC_PPI TIMER_PHYS_NONSECURE_PPI (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
			     <GIC_PPI TIMER_VIRT_PPI           (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
			     <GIC_PPI TIMER_HYP_PPI            (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>;
	};

	pmu {
		compatible = "arm,armv8-pmuv3";
		interrupts = <GIC_SPI PMU_CORE0_SPI IRQ_TYPE_LEVEL_HIGH>,
			     <GIC_SPI PMU_CORE1_SPI IRQ_TYPE_LEVEL_HIGH>;
		interrupt-affinity = <&B53_0> ,<&B53_1>;
	};
	
	brcm-legacy {
		compatible = "brcm,brcm-legacy";
	};

	memory@00000000 {
		device_type = "memory";
		reg = <0x00000000 DRAM_BASE 0x0 DRAM_DEF_SIZE>;  /* 64MBMB */
	};

    clocks {
      #address-cells = <1>;
      #size-cells = <1>;
      ranges;

      i2s_clkmclk_syscon: i2s_clkmclk_syscon@0xFF802080 {
         compatible = "brcm,i2s-audio-clkmclk-syscon", "syscon";
         reg = <0xFF802080 0x4>;
      };

      osc: oscillator {
        #clock-cells = <0>;
        compatible = "fixed-clock";
        clock-frequency = <50000000>; /* xpon 50MHz output */
      };

      i2sclk: i2sclk@0x80158000 {
        #clock-cells = <0>;
        compatible = "brcm,i2s-clock";
        clocks = <&osc>;
        clk-mclk-syscon        = <&i2s_clkmclk_syscon>;
        clock-output-names     = "i2s_clk";
      };
    };

	/* Legacy UBUS base */
	ubus@ff800000 {
		compatible = "simple-bus";
		#address-cells = <2>;
		#size-cells = <2>;
		ranges = <0x0 0x0 0x0 0xff800000 0x0 0x62000>;

		nand@ff801800 {
			#address-cells = <1>;
			#size-cells = <0>;
			compatible = "brcm,nand-bcm63xx", "brcm,brcmnand-v7.1";
			reg = <0x0 0x1800 0x0 0x600>, <0x0 0x2000 0x0 0x10>;
			reg-names = "nand", "nand-int-base";
			status = "okay";

			nandcs@0 {
				compatible = "brcm,nandcs";
				reg = <0>;
				nand-on-flash-bbt;
			};

		};

		watchdog@ff800428 {
			compatible = "brcm,bcm96xxx-wdt";
			reg = <0x0 0x428 0x0 0x10>;
			timeout-sec = <80>;
		};

		i2s: bcm63xx-i2s@ff802080 {
			compatible = "brcm,bcm63xx-i2s";
			reg = <0 0x2080 0 0x21>; 
			clocks = <&i2sclk>, <&osc>;
			clock-names = "i2sclk","i2sosc";
		};

		i2c_0: i2c@ff802100 {
			compatible = "brcm,bcm63000-i2c";
			reg = <0x0 0x2100 0x0 0x60>;
		};

		sdhci: sdhci@ff858000 {
		    compatible = "brcm,bcm63xx-sdhci";
		   	reg = <0x00000000 0x58000 0x00000000 0x100>;
			interrupts = <GIC_SPI SDIO_EMMC_SPI IRQ_TYPE_LEVEL_HIGH>;
			bus-width = <8>;
			non-removable;
#ifdef EMMC_DDR_1_8V 
			mmc-ddr-1_8v;
#endif
		};

		rng: rng@ff800b80 {
			compatible = "brcm,iproc-rng200";
			reg = <0x0 0x00000b80 0x0 0x28>;
		};

	};

	pcm5100 {
		compatible = "brcm,pcm5100";
	};

	bcm63xx-pcm-audio {
		compatible = "brcm,bcm63xx-pcm-audio";
		interrupts = <GIC_SPI 84 IRQ_TYPE_LEVEL_HIGH>;
	};

    /* increase coherent_pool size */
	chosen {
		bootargs = "coherent_pool=4M cpuidle_sysfs_switch pci=pcie_bus_safe";
	};

#if defined(CONFIG_BCM_PCIE_HCD)
	pcie0: pcie@80040000 {
		compatible = "brcm,bcm963xx-pcie";
		device_type = "pci";
		reg = <0 0x80040000 0 0x0000A000>;

		#address-cells = <3>;
		#size-cells = <2>;
		/*        flags,     pci_addr,    cpu_addr     size */
		ranges = <0x02000000 0 0x90000000 0 0x90000000 0 0x10000000>;

		/* core error log interrupts */
		interrupt-names = "intr";
		interrupts = <GIC_SPI 60 IRQ_TYPE_LEVEL_HIGH>;

		#interrupt-cells = <1>;
		interrupt-map-mask = <0 0 0 0>;
		interrupt-map = <0 0 0 0 &gic GIC_SPI 60 IRQ_TYPE_LEVEL_HIGH>;

		brcm,coreid = <0>;
	};

	pcie1: pcie@80050000 {
		compatible = "brcm,bcm963xx-pcie";
		device_type = "pci";
		reg = <0 0x80050000 0 0x0000A000>;

		#address-cells = <3>;
		#size-cells = <2>;
		/*        flags,     pci_addr,    cpu_addr     size */
		ranges = <0x02000000 0 0xA0000000 0 0xA0000000 0 0x10000000>;

		/* core error log interrupts */
		interrupt-names = "intr";
		interrupts = <GIC_SPI 61 IRQ_TYPE_LEVEL_HIGH>;

		#interrupt-cells = <1>;
		interrupt-map-mask = <0 0 0 0>;
		interrupt-map = <0 0 0 0 &gic GIC_SPI 61 IRQ_TYPE_LEVEL_HIGH>;

		brcm,coreid = <1>;
	};

	pcie2: pcie@80060000 {
		compatible = "brcm,bcm963xx-pcie";
		device_type = "pci";
		reg = <0 0x80060000 0 0x0000A000>;

		#address-cells = <3>;
		#size-cells = <2>;
		/*        flags,     pci_addr,    cpu_addr     size */
		ranges = <0x02000000 0 0xB0000000 0 0xB0000000 0 0x10000000>;

		/* core error log interrupts */
		interrupt-names = "intr";
		interrupts = <GIC_SPI 62 IRQ_TYPE_LEVEL_HIGH>;

		#interrupt-cells = <1>;
		interrupt-map-mask = <0 0 0 0>;
		interrupt-map = <0 0 0 0 &gic GIC_SPI 62 IRQ_TYPE_LEVEL_HIGH>;

		brcm,coreid = <2>;
	};
#endif
};