# # Alteon network device configuration # config NET_VENDOR_ALTEON bool "Alteon devices" default y depends on PCI ---help--- If you have a network (Ethernet) card belonging to this class, say Y and read the Ethernet-HOWTO, available from . Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about Alteon cards. If you say Y, you will be asked for your specific card in the following questions. if NET_VENDOR_ALTEON config ACENIC tristate "Alteon AceNIC/3Com 3C985/NetGear GA620 Gigabit support" depends on PCI ---help--- Say Y here if you have an Alteon AceNIC, 3Com 3C985(B), NetGear GA620, SGI Gigabit or Farallon PN9000-SX PCI Gigabit Ethernet adapter. The driver allows for using the Jumbo Frame option (9000 bytes/frame) however it requires that your switches can handle this as well. To enable Jumbo Frames, add `mtu 9000' to your ifconfig line. To compile this driver as a module, choose M here: the module will be called acenic. config ACENIC_OMIT_TIGON_I bool "Omit support for old Tigon I based AceNICs" depends on ACENIC ---help--- Say Y here if you only have Tigon II based AceNICs and want to leave out support for the older Tigon I based cards which are no longer being sold (ie. the original Alteon AceNIC and 3Com 3C985 (non B version)). This will reduce the size of the driver object by app. 100KB. If you are not sure whether your card is a Tigon I or a Tigon II, say N here. The safe and default value for this is N. endif # NET_VENDOR_ALTEON