#include "6756.dtsi"

/ {
	memory_controller {
		memcfg = <(BP_DDR_TYPE_DDR4           | \
			BP_DDR_SPEED_1067_15_15_15 | \
			BP_DDR_TOTAL_SIZE_1024MB   | \
			BP_DDR_DEVICE_WIDTH_16     | \
			BP_DDR_TOTAL_WIDTH_16BIT   | \
			BP_DDR_6756_DEFAULT)>;
	};
};


&mdio_sf2 {
	phy_ge:8 {
		status = "okay";
	};
	phy_cascade0:cascade0 {
		reg = <28>;
		phy-reset = <&gpioc 10 GPIO_ACTIVE_LOW>;
		enet-phy-lane-swap;
		status = "okay";
	};
	phy_serdes0:serdes0 {
		phy-handle = <&phy_cascade0>;
		status = "okay";
	};
	phy_cascade1:cascade1 {
		reg = <30>;
		phy-reset = <&gpioc 32 GPIO_ACTIVE_LOW>;
		enet-phy-lane-swap;
		status = "okay";
	};
	phy_serdes1:serdes1 {
		phy-handle = <&phy_cascade1>;
		status = "okay";
	};
};

&switch0 {
	pinctrl-names = "default"; 
	pinctrl-0 = <&a_rgmii_mdc_pin_68 &a_rgmii_mdio_pin_69>; 

	ports {
		port0@0 {
			phy-handle = <&phy_ge>;
			status = "okay";
		};
		port5@5 {
			phy-handle = <&phy_serdes0>;
			status = "okay";
		};
		port6@6 {
			phy-handle = <&phy_serdes1>;
			status = "okay";
		};
	};
};

&usb_ctrl {
	pinctrl-names="default";
	pinctrl-0 = <&usb0_pwr_pins &usb1_pwr_pins>;
	pwron-bias-pull-up;
	status = "okay";
	xhci-enable;
};

&usb0_xhci {
	status = "okay";
};

&usb0_ehci {
	status = "okay";
};

&usb1_ehci {
	status = "okay";
};

&usb0_ohci {
	status = "okay";
};

&usb1_ohci {
	status = "okay";
};