#include "6756.dtsi"
#include "../bcm_voice.dtsi"

/ {
	memory_controller {
		memcfg = <(BP_DDR_SPEED_1067_14_14_14 | \
			BP_DDR_TOTAL_SIZE_512MB    | \
			BP_DDR_DEVICE_WIDTH_16     | \
			BP_DDR_TOTAL_WIDTH_16BIT   | \
			BP_DDR_6756_DEFAULT)>;
	};
};

&bcm_voice{
	sliclist = SLICSLAC_LIST_COMMON_NOFXO;
 };

&hsspi {
	voice0 {
		pinctrl-0 = <&spim_ss1_b_pin_76>;
		pinctrl-names = "default";
		compatible = "bcm-spi-voice";
		reg = <1>; /* chip select 1 */
		spi-max-frequency = <1024000>;
		reset-gpio = <&gpioc 30 GPIO_ACTIVE_LOW>;
		spi-index = <0>;/* voice header index */
	};
};

&mdio_sf2 {
	phy_ge:8 {
		status = "okay";
	};
	phy_serdes0:serdes0 {
		status = "okay";
	};
	phy_serdes1:serdes1 {
		status = "okay";
	};
};

&switch0 {
	pinctrl-names = "default"; 
	pinctrl-0 = <&a_rgmii_mdc_pin_68 &a_rgmii_mdio_pin_69>; 

	ports {
		port0@0 {
			phy-handle = <&phy_ge>;
			status = "okay";
		};
		port5@5 {
			phy-handle = <&phy_serdes0>;
			status = "okay";
		};
		port6@6 {
			phy-handle = <&phy_serdes1>;
			status = "okay";
		};
	};
};


&usb_ctrl {
	pinctrl-names="default";
	pinctrl-0 = <&usb0_pwr_pins &usb1_pwr_pins>;
	status = "okay";
	xhci-enable;
};

&usb0_xhci {
	status = "okay";
};

&usb0_ehci {
	status = "okay";
};

&usb1_ehci {
	status = "okay";
};

&usb0_ohci {
	status = "okay";
};

&usb1_ohci {
	status = "okay";
};

&hs_uart0 {
	status = "okay";
};

&i2c0 {
	pinctrl-names="default";
	pinctrl-0 = <&i2c_sda_pin_16 &i2c_scl_pin_17>;
	status = "okay";
};

&i2c1 {
	pinctrl-names="default";
	pinctrl-0 = <&a_i2c1_sda_pin_7 &a_i2c1_scl_pin_8>;
	status = "okay";
};