# # 802.1d Ethernet Bridging # config BRIDGE tristate "802.1d Ethernet Bridging" select LLC select STP depends on IPV6 || IPV6=n ---help--- If you say Y here, then your Linux box will be able to act as an Ethernet bridge, which means that the different Ethernet segments it is connected to will appear as one Ethernet to the participants. Several such bridges can work together to create even larger networks of Ethernets using the IEEE 802.1 spanning tree algorithm. As this is a standard, Linux bridges will cooperate properly with other third party bridge products. In order to use the Ethernet bridge, you'll need the bridge configuration tools; see for location. Please read the Bridge mini-HOWTO for more information. If you enable iptables support along with the bridge support then you turn your bridge into a bridging IP firewall. iptables will then see the IP packets being bridged, so you need to take this into account when setting up your firewall rules. Enabling arptables support when bridging will let arptables see bridged ARP traffic in the arptables FORWARD chain. To compile this code as a module, choose M here: the module will be called bridge. If unsure, say N. config AVM_BRIDGE_FLOOD_RATELIMITER bool "Port flood rate limiting" depends on AVM_ENHANCED depends on BRIDGE default y ---help--- AVM extension This enables a simple, configurable bridge flood rate limiting mechanism, to help protect accidental or willful network loops. You can configure a maximum packet rate and a reserve. The reserve can be higher to allow for short bursts. The ratelimiter will only limit packets which are forwarded on all ports. Traffic (unicast and multicast) that is forwarded to specific ports is unaffected. Locally generated traffic is unaffected as well. It is disabled by default and must be configured through sysfs. config BRIDGE_IGMP_SNOOPING bool "IGMP/MLD snooping" depends on BRIDGE depends on INET default y ---help--- If you say Y here, then the Ethernet bridge will be able selectively forward multicast traffic based on IGMP/MLD traffic received from each port. Say N to exclude this support and reduce the binary size. If unsure, say Y. config BRIDGE_VLAN_FILTERING bool "VLAN filtering" depends on BRIDGE depends on VLAN_8021Q default n ---help--- If you say Y here, then the Ethernet bridge will be able selectively receive and forward traffic based on VLAN information in the packet any VLAN information configured on the bridge port or bridge device. Say N to exclude this support and reduce the binary size. If unsure, say Y. config MCAST_PROXY tristate "MCAST Proxy support" depends on m default n help Lantiq Multicast Proxy support config MCAST_SNOOPING bool "MCAST Snooping support" default n help Lantiq Multicast Snooping support