QCOM ADM DMA Controller

Required properties:
- compatible: must contain "qcom,adm" for IPQ/APQ8064 and MSM8960
- reg: Address range for DMA registers
- interrupts: Should contain one interrupt shared by all channels
- #dma-cells: must be <1>.  First cell denotes the channel number.
- clocks: Should contain the core clock and interface clock.
- clock-names: Must contain "core" for the core clock and "iface" for the
  interface clock.
- resets: Must contain an entry for each entry in reset names.
- reset-names: Must include the following entries:
  - clk
  - c0
  - c1
  - c2
- qcom,ee: indicates the security domain identifier used in the secure world.

Example:
		adm_dma: dma@18300000 {
			compatible = "qcom,adm";
			reg = <0x18300000 0x100000>;
			interrupts = <0 170 0>;
			#dma-cells = <1>;

			clocks = <&gcc ADM0_CLK>, <&gcc ADM0_PBUS_CLK>;
			clock-names = "core", "iface";

			resets = <&gcc ADM0_RESET>,
				<&gcc ADM0_C0_RESET>,
				<&gcc ADM0_C1_RESET>,
				<&gcc ADM0_C2_RESET>;
			reset-names = "clk", "c0", "c1", "c2";
			qcom,ee = <0>;
		};

DMA clients must use the format descripted in the dma.txt file, using a two
cell specifier for each channel.

Each dmas request consists of two cells:
 1. phandle pointing to the DMA controller
 2. channel number

Example:

	spi4: spi@1a280000 {
		status = "ok";
		spi-max-frequency = <50000000>;

		pinctrl-0 = <&spi_pins>;
		pinctrl-names = "default";

		cs-gpios = <&qcom_pinmux 20 0>;

		dmas = <&adm_dma 6>,
			<&adm_dma 5>;
		dma-names = "rx", "tx";
	};