# # Myricom device configuration # config NET_VENDOR_MYRI bool "Myricom devices" default y depends on PCI && INET ---help--- If you have a network (Ethernet) card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about Myricom cards. If you say Y, you will be asked for your specific card in the following questions. if NET_VENDOR_MYRI config MYRI10GE tristate "Myricom Myri-10G Ethernet support" depends on PCI && INET select FW_LOADER select CRC32 ---help--- This driver supports Myricom Myri-10G Dual Protocol interface in Ethernet mode. If the eeprom on your board is not recent enough, you will need a newer firmware image. You may get this image or more information, at: To compile this driver as a module, choose M here. The module will be called myri10ge. config MYRI10GE_DCA bool "Direct Cache Access (DCA) Support" default y depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m) ---help--- Say Y here if you want to use Direct Cache Access (DCA) in the driver. DCA is a method for warming the CPU cache before data is used, with the intent of lessening the impact of cache misses. endif # NET_VENDOR_MYRI