# # Micrel device configuration # config NET_VENDOR_MICREL bool "Micrel devices" default y depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM || \ (ARM && ARCH_KS8695) ---help--- If you have a network (Ethernet) card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about Micrel devices. If you say Y, you will be asked for your specific card in the following questions. if NET_VENDOR_MICREL config ARM_KS8695_ETHER tristate "KS8695 Ethernet support" depends on ARM && ARCH_KS8695 select MII ---help--- If you wish to compile a kernel for the KS8695 and want to use the internal ethernet then you should answer Y to this. config KS8842 tristate "Micrel KSZ8841/42 with generic bus interface" depends on HAS_IOMEM && DMA_ENGINE ---help--- This platform driver is for KSZ8841(1-port) / KS8842(2-port) ethernet switch chip (managed, VLAN, QoS) from Micrel or Timberdale(FPGA). config KS8851 tristate "Micrel KS8851 SPI" depends on SPI select MII select CRC32 select EEPROM_93CX6 ---help--- SPI driver for Micrel KS8851 SPI attached network chip. config KS8851_MLL tristate "Micrel KS8851 MLL" depends on HAS_IOMEM select MII ---help--- This platform driver is for Micrel KS8851 Address/data bus multiplexed network chip. config KSZ884X_PCI tristate "Micrel KSZ8841/2 PCI" depends on PCI select MII select CRC32 ---help--- This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip. To compile this driver as a module, choose M here. The module will be called ksz884x. endif # NET_VENDOR_MICREL