// SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)

/dts-v1/;

#define __IPQ_MEM_PROFILE_512_MB__ 1

#include "ipq5332-512MB-memory.dtsi"
#include "ipq5332-avm-common.dtsi"

/ {
	#address-cells = <0x2>;
	#size-cells = <0x2>;
	model = "FRITZ!Repeater 2400W7";

	avm-wkk-extra-resets {
		compatible = "avm,gpio-aggregator";
		pinctrl-0 = <&avm_wkk_extra_reset_pins>;
		pinctrl-names = "default";

		gpios = <&tlmm 49 GPIO_ACTIVE_LOW>;
		gpio-line-names = "wkk_5g_reset";
	};

	avm-hui {
		compatible = "avm,hui";
		pinctrl-names = "default";
		pinctrl-0 = <&avm_connect_gpio>;
		status = "ok";

		repeater-connect {
			compatible = "avm,hui-generic-button-gpio";
			gpios = <&tlmm 23 GPIO_ACTIVE_LOW>;
		};
	};

	soc {
		pinctrl@1000000 {
			/* ina2xx pins*/
			ina2xx_i2c_pins: ina2xx-i2c-pins {
				pins = "gpio43", "gpio45"; /* SCL, SDA */
				function = "blsp2_i2c0";
				drive-strength = <8>;
				bias-disable;
			};

			/* ina2xx alert pin */
			ina2xx_alert_pin: ina2xx-alert-pin {
				pins = "gpio24";
				drive-strength = <8>;
				bias-disable;
			};

			avm_wkk_extra_reset_pins: avm-wkk-extra-reset-pins {
				wkk_5g_pin {
					pins = "gpio49";
					function = "gpio";
					drive-strength = <8>;
					output-high;
				};
			};

			avm_connect_gpio: avm_connect_gpio {
				pins = "gpio23";
				function = "gpio";
				drive-strength = <2>;
				bias-disable;
			};

			mdio1_pins: mdio_pinmux {
				mux_0 {
					pins = "gpio27";
					function = "mdc1";
					drive-strength = <8>;
					bias-disable;
				};
				mux_1 {
					pins = "gpio28";
					function = "mdio1";
					drive-strength = <8>;
					bias-pull-up;
				};
			};
		};

		/* BLSP3 which is configured from spi to i2c */
		i2c_2: i2c@78b7000 {
			compatible = "qcom,i2c-qup-v2.2.1";
			#address-cells = <1>;
			#size-cells = <0>;
			reg = <0x078b7000 0x600>;
			interrupts = <GIC_SPI 294 IRQ_TYPE_LEVEL_HIGH>;
			clock-frequency  = <400000>;
			clocks = <&gcc GCC_BLSP1_QUP3_I2C_APPS_CLK>,
				<&gcc GCC_BLSP1_AHB_CLK>;
			clock-names = "core", "iface";
			dmas = <&blsp_dma 8>, <&blsp_dma 9>;
			dma-names = "tx", "rx";

			pinctrl-0 = <&ina2xx_i2c_pins>;
			pinctrl-names = "default";
			status = "ok";

			ina236@40 {
				compatible = "ti,ina236";
				reg = <0x40>;
				pinctrl-0 = <&ina2xx_alert_pin>;
				pinctrl-names = "default";
				shunt-resistor = <15000>;
				interrupts-extended = <&tlmm 24 IRQ_TYPE_EDGE_FALLING>;
				interrupt-names = "alert";
				alert-type = <12>; /* bus undervoltage */
				alert-limit = <10800>; /* 10,8V */
			};
		};

		avm_mac_addr_maceth_0: dp1 {
			device_type = "network";
			compatible = "qcom,nss-dp";
			qcom,id = <2>;
			reg = <0x3a504000 0x4000>;
			qcom,mactype = <1>;
			mac-address = [000000000000];
			mdio-bus = <&mdio>;
			qcom,phy-mdio-addr = <28>;
			qcom,link-poll = <1>;
			devname = "eth0";
			phy-mode = "sgmii";
		};

		mdio:mdio@90000 {
			status = "ok";
			pinctrl-0 = <&mdio1_pins>;
			pinctrl-names = "default";
			/*gpio51 for nappa reset*/
			phy-reset-gpio = <&tlmm 51 GPIO_ACTIVE_HIGH>;
			phyaddr_fixup = <0xC90F018>;
			uniphyaddr_fixup = <0xC90F014>;
			mdio_clk_fixup; /* MDIO clock sequence fix up flag */

			phy0: ethernet-phy@0 {
				reg = <28>;
			};
		};

		ess-instance {
			num_devices = <0x1>;
			ppe_switch: ess-switch@3a000000 {
				switch_cpu_bmp = <0x1>;  /* cpu port bitmap */
				switch_lan_bmp = <0x4>; /* lan port bitmap */
				switch_wan_bmp = <0x0>; /* wan port bitmap */
				switch_mac_mode = <0x0c>; /* mac mode for uniphy instance0*/
				switch_mac_mode1 = <0xff>; /* mac mode for uniphy instance1*/
				switch_mac_mode2 = <0xff>; /* mac mode for uniphy instance2*/

				qcom,port_phyinfo {
					port@0 {
						port_id = <2>;
						phy_address = <28>;
						port_mac_sel = "QGMAC_PORT";
					};
				};
			};
		};
	};
};

/* nand */
&nand {
	status = "ok";
};

&qpic_bam {
	status = "ok";
};

//TODO: Verify wifi configuration

/* WiFi global memory */
&mlo_global_mem0 {
	size = <0x0 0xD00000>;
	status = "ok";
};

&pcie2_phy {
	status = "ok";
};

/* Waikiki 5G */
&pcie2 {
	status = "ok";
	perst-gpio = <&tlmm 38 GPIO_ACTIVE_LOW>;
};
&pcie2_rp {
	reg = <0 0 0 0 0>;

	wifi@2 {
		reg = <0 0 0 0 0>;
		license-file = "qcn9224/license.dat";
		qrtr_node_id = <0x31>;
		memory-region = <0>,<&mhi_region1>;
		qti,disable-rddm-prealloc;
		qti,rddm-seg-len = <0x1000>;
		status = "ok";
	};
};
&pci2_pin {
	pins = "gpio38";
};

&qcn9224_pcie1 {
	status = "ok";
};

&mhi_region1 {
	status = "ok";
	size = <0x0 0x00f00000>;
};

&wifi2 {
	hremote_node = <&qcn9224_pcie1>;
	board_id = <0x0002>;
	status = "ok";
};

/* internal wifi: disabled */
&wifi0 {
	status = "ok";
};
&q6_region {
	status = "ok";
};
&m3_dump {
	status = "ok";
};
&q6_etr_region {
	status = "ok";
};
&q6_caldb_region {
	status = "ok";
};

/* Remove unused avm special mac address definitions */
/delete-node/ &avm_mac_addr_macrouter_3;
/delete-node/ &avm_mac_addr_macvoip_0;