#ifndef _ATARI_SCCSERIAL_H #define _ATARI_SCCSERIAL_H /* Special configuration ioctls for the Atari SCC5380 Serial * Communications Controller */ /* ioctl command codes */ #define TIOCGATSCC 0x54c0 /* get SCC configuration */ #define TIOCSATSCC 0x54c1 /* set SCC configuration */ #define TIOCDATSCC 0x54c2 /* reset configuration to defaults */ /* Clock sources */ #define CLK_RTxC 0 #define CLK_TRxC 1 #define CLK_PCLK 2 /* baud_bases for the common clocks in the Atari. These are the real * frequencies divided by 16. */ #define SCC_BAUD_BASE_TIMC 19200 /* 0.3072 MHz from TT-MFP, Timer C */ #define SCC_BAUD_BASE_BCLK 153600 /* 2.4576 MHz */ #define SCC_BAUD_BASE_PCLK4 229500 /* 3.6720 MHz */ #define SCC_BAUD_BASE_PCLK 503374 /* 8.0539763 MHz */ #define SCC_BAUD_BASE_NONE 0 /* for not connected or unused * clock sources */ #define SCC_BAUD_BASE_M147_PCLK 312500 /* 5 MHz */ #define SCC_BAUD_BASE_M147 312500 /* 5 MHz */ #define SCC_BAUD_BASE_MVME_PCLK 781250 /* 12.5 MHz */ #define SCC_BAUD_BASE_MVME 625000 /* 10.000 MHz */ #define SCC_BAUD_BASE_BVME_PCLK 781250 /* 12.5 MHz */ /* XXX ??? */ #define SCC_BAUD_BASE_BVME 460800 /* 7.3728 MHz */ /* The SCC configuration structure */ struct atari_SCCserial { unsigned RTxC_base; /* base_baud of RTxC */ unsigned TRxC_base; /* base_baud of TRxC */ unsigned PCLK_base; /* base_baud of PCLK, for both channels! */ struct { unsigned clksrc; /* CLK_RTxC, CLK_TRxC or CLK_PCLK */ unsigned divisor; /* divisor for base baud, valid values: * see below */ } baud_table[17]; /* For 50, 75, 110, 135, 150, 200, 300, * 600, 1200, 1800, 2400, 4800, 9600, * 19200, 38400, 57600 and 115200 bps. The * last two could be replaced by other * rates > 38400 if they're not possible. */ }; /* The following divisors are valid: * * - CLK_RTxC: 1 or even (1, 2 and 4 are the direct modes, > 4 use * the BRG) * * - CLK_TRxC: 1, 2 or 4 (no BRG, only direct modes possible) * * - CLK_PCLK: >= 4 and even (no direct modes, only BRG) * */ #endif /* _ATARI_SCCSERIAL_H */