--- zzzz-none-000/linux-2.6.39.4/arch/arm/plat-omap/Kconfig	2011-08-03 19:43:28.000000000 +0000
+++ puma6-atom-6490-729/linux-2.6.39.4/arch/arm/plat-omap/Kconfig	2021-11-10 13:38:14.000000000 +0000
@@ -79,6 +79,39 @@
 	  probably do not want this option enabled until your
 	  device drivers work properly.
 
+config OMAP_BOOT_TAG
+	bool "OMAP bootloader information passing"
+        depends on ARCH_OMAP
+        default n
+        help
+          Say Y, if you have a bootloader which passes information
+          about your board and its peripheral configuration.
+
+config OMAP_BOOT_REASON
+	bool "Support for boot reason"
+        depends on OMAP_BOOT_TAG
+        default n
+        help
+          Say Y, if you want to have a procfs entry for reading the boot
+          reason in user-space.
+
+config OMAP_COMPONENT_VERSION
+	bool "Support for component version display"
+	depends on OMAP_BOOT_TAG && PROC_FS
+	default n
+	help
+	  Say Y, if you want to have a procfs entry for reading component
+	  versions (supplied by the bootloader) in user-space.
+
+config OMAP_GPIO_SWITCH
+	bool "GPIO switch support"
+        default n
+        help
+          Say Y, if you want to have support for reporting of GPIO
+          switches (e.g. cover switches) via sysfs. Your bootloader has
+          to provide information about the switches to the kernel via the
+          ATAG_BOARD mechanism if they're not defined by the board config.
+
 config OMAP_MUX
 	bool "OMAP multiplexing support"
 	depends on ARCH_OMAP
@@ -191,10 +224,26 @@
 
 config OMAP_DM_TIMER
 	bool "Use dual-mode timer"
-	depends on ARCH_OMAP16XX || ARCH_OMAP2PLUS
+	depends on ARCH_OMAP16XX || ARCH_OMAP24XX
 	help
 	 Select this option if you want to use OMAP Dual-Mode timers.
 
+choice
+	prompt "Low-level debug console UART"
+	depends on ARCH_OMAP
+	default OMAP_LL_DEBUG_UART1
+
+config OMAP_LL_DEBUG_UART1
+	bool "UART1"
+
+config OMAP_LL_DEBUG_UART2
+	bool "UART2"
+
+config OMAP_LL_DEBUG_UART3
+	bool "UART3"
+
+endchoice
+
 config OMAP_SERIAL_WAKE
 	bool "Enable wake-up events for serial ports"
 	depends on ARCH_OMAP1 && OMAP_MUX
@@ -217,6 +266,8 @@
 
 endchoice
 
+source "arch/arm/plat-omap/dsp/Kconfig"
+
 endmenu
 
 endif