# # ARC EMAC network device configuration # config NET_VENDOR_ARC bool "ARC devices" default y ---help--- If you have a network (Ethernet) card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about ARC cards. If you say Y, you will be asked for your specific card in the following questions. if NET_VENDOR_ARC config ARC_EMAC_CORE tristate select MII select PHYLIB config ARC_EMAC tristate "ARC EMAC support" select ARC_EMAC_CORE depends on OF_IRQ && OF_NET && HAS_DMA ---help--- On some legacy ARC (Synopsys) FPGA boards such as ARCAngel4/ML50x non-standard on-chip ethernet device ARC EMAC 10/100 is used. Say Y here if you have such a board. If unsure, say N. config EMAC_ROCKCHIP tristate "Rockchip EMAC support" select ARC_EMAC_CORE depends on OF_IRQ && OF_NET && REGULATOR && HAS_DMA ---help--- Support for Rockchip RK3066/RK3188 EMAC ethernet controllers. This selects Rockchip SoC glue layer support for the emac device driver. This driver is used for RK3066/RK3188 EMAC ethernet controller. endif # NET_VENDOR_ARC