--- zzzz-none-000/linux-3.10.107/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt	2021-02-04 17:41:59.000000000 +0000
@@ -6,9 +6,14 @@
 
 Required properties:
 - name : Should be pmc
-- compatible : Should contain "nvidia,tegra<chip>-pmc".
+- compatible : For Tegra20, must contain "nvidia,tegra20-pmc".  For Tegra30,
+  must contain "nvidia,tegra30-pmc".  For Tegra114, must contain
+  "nvidia,tegra114-pmc".  For Tegra124, must contain "nvidia,tegra124-pmc".
+  Otherwise, must contain "nvidia,<chip>-pmc", plus at least one of the
+  above, where <chip> is tegra132.
 - reg : Offset and length of the register set for the device
 - clocks : Must contain an entry for each entry in clock-names.
+  See ../clocks/clock-bindings.txt for details.
 - clock-names : Must include the following entries:
   "pclk" (The Tegra clock of that name),
   "clk32k_in" (The 32KHz clock input to Tegra).
@@ -46,6 +51,23 @@
   sleep mode, the warm boot code will restore some PLLs, clocks and then
   bring up CPU0 for resuming the system.
 
+Hardware-triggered thermal reset:
+On Tegra30, Tegra114 and Tegra124, if the 'i2c-thermtrip' subnode exists,
+hardware-triggered thermal reset will be enabled.
+
+Required properties for hardware-triggered thermal reset (inside 'i2c-thermtrip'):
+- nvidia,i2c-controller-id : ID of I2C controller to send poweroff command to. Valid values are
+                             described in section 9.2.148 "APBDEV_PMC_SCRATCH53_0" of the
+                             Tegra K1 Technical Reference Manual.
+- nvidia,bus-addr : Bus address of the PMU on the I2C bus
+- nvidia,reg-addr : I2C register address to write poweroff command to
+- nvidia,reg-data : Poweroff command to write to PMU
+
+Optional properties for hardware-triggered thermal reset (inside 'i2c-thermtrip'):
+- nvidia,pinmux-id : Pinmux used by the hardware when issuing poweroff command.
+                     Defaults to 0. Valid values are described in section 12.5.2
+                     "Pinmux Support" of the Tegra4 Technical Reference Manual.
+
 Example:
 
 / SoC dts including file
@@ -68,6 +90,15 @@
 / Tegra board dts file
 {
 	...
+	pmc@7000f400 {
+		i2c-thermtrip {
+			nvidia,i2c-controller-id = <4>;
+			nvidia,bus-addr = <0x40>;
+			nvidia,reg-addr = <0x36>;
+			nvidia,reg-data = <0x2>;
+		};
+	};
+	...
 	clocks {
 		compatible = "simple-bus";
 		#address-cells = <1>;