--- zzzz-none-000/linux-3.10.107/Documentation/devicetree/bindings/gpio/gpio-samsung.txt	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/Documentation/devicetree/bindings/gpio/gpio-samsung.txt	2021-02-04 17:41:59.000000000 +0000
@@ -39,46 +39,3 @@
 		#gpio-cells = <4>;
 		gpio-controller;
 	};
-
-
-Samsung S3C24XX GPIO Controller
-
-Required properties:
-- compatible: Compatible property value should be "samsung,s3c24xx-gpio".
-
-- reg: Physical base address of the controller and length of memory mapped
-  region.
-
-- #gpio-cells: Should be 3. The syntax of the gpio specifier used by client nodes
-  should be the following with values derived from the SoC user manual.
-     <[phandle of the gpio controller node]
-      [pin number within the gpio controller]
-      [mux function]
-      [flags and pull up/down]
-
-  Values for gpio specifier:
-  - Pin number: depending on the controller a number from 0 up to 15.
-  - Mux function: Depending on the SoC and the gpio bank the gpio can be set
-                  as input, output or a special function
-  - Flags and Pull Up/Down: the values to use differ for the individual SoCs
-                    example S3C2416/S3C2450:
-                            0 - Pull Up/Down Disabled.
-                            1 - Pull Down Enabled.
-                            2 - Pull Up Enabled.
-          Bit 16 (0x00010000) - Input is active low.
-  Consult the user manual for the correct values of Mux and Pull Up/Down.
-
-- gpio-controller: Specifies that the node is a gpio controller.
-- #address-cells: should be 1.
-- #size-cells: should be 1.
-
-Example:
-
-	gpa: gpio-controller@56000000 {
-		#address-cells = <1>;
-		#size-cells = <1>;
-		compatible = "samsung,s3c24xx-gpio";
-		reg = <0x56000000 0x10>;
-		#gpio-cells = <3>;
-		gpio-controller;
-	};