--- zzzz-none-000/linux-3.10.107/Documentation/devicetree/bindings/leds/leds-gpio.txt	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/Documentation/devicetree/bindings/leds/leds-gpio.txt	2021-02-04 17:41:59.000000000 +0000
@@ -21,19 +21,23 @@
   on).  The "keep" setting will keep the LED at whatever its current
   state is, without producing a glitch.  The default is off if this
   property is not present.
+- retain-state-suspended: (optional) The suspend state can be retained.Such
+  as charge-led gpio.
 
 Examples:
 
+#include <dt-bindings/gpio/gpio.h>
+
 leds {
 	compatible = "gpio-leds";
 	hdd {
 		label = "IDE Activity";
-		gpios = <&mcu_pio 0 1>; /* Active low */
+		gpios = <&mcu_pio 0 GPIO_ACTIVE_LOW>;
 		linux,default-trigger = "ide-disk";
 	};
 
 	fault {
-		gpios = <&mcu_pio 1 0>;
+		gpios = <&mcu_pio 1 GPIO_ACTIVE_HIGH>;
 		/* Keep LED on if BIOS detected hardware fault */
 		default-state = "keep";
 	};
@@ -42,11 +46,21 @@
 run-control {
 	compatible = "gpio-leds";
 	red {
-		gpios = <&mpc8572 6 0>;
+		gpios = <&mpc8572 6 GPIO_ACTIVE_HIGH>;
 		default-state = "off";
 	};
 	green {
-		gpios = <&mpc8572 7 0>;
+		gpios = <&mpc8572 7 GPIO_ACTIVE_HIGH>;
 		default-state = "on";
 	};
 };
+
+leds {
+	compatible = "gpio-leds";
+
+	charger-led {
+		gpios = <&gpio1 2 GPIO_ACTIVE_HIGH>;
+		linux,default-trigger = "max8903-charger-charging";
+		retain-state-suspended;
+	};
+};