--- zzzz-none-000/linux-3.10.107/Documentation/devicetree/bindings/mtd/atmel-nand.txt	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/Documentation/devicetree/bindings/mtd/atmel-nand.txt	2021-02-04 17:41:59.000000000 +0000
@@ -1,11 +1,13 @@
 Atmel NAND flash
 
 Required properties:
-- compatible : "atmel,at91rm9200-nand".
+- compatible : should be "atmel,at91rm9200-nand" or "atmel,sama5d4-nand".
 - reg : should specify localbus address and size used for the chip,
 	and hardware ECC controller if available.
 	If the hardware ECC is PMECC, it should contain address and size for
-	PMECC, PMECC Error Location controller and ROM which has lookup tables.
+	PMECC and PMECC Error Location controller.
+	The PMECC lookup table address and size in ROM is optional. If not
+	specified, driver will build it in runtime.
 - atmel,nand-addr-offset : offset for the address latch.
 - atmel,nand-cmd-offset : offset for the command latch.
 - #address-cells, #size-cells : Must be present if the device has sub-nodes
@@ -15,6 +17,7 @@
   optional gpio and may be set to 0 if not present.
 
 Optional properties:
+- atmel,nand-has-dma : boolean to support dma transfer for nand read/write.
 - nand-ecc-mode : String, operation mode of the NAND ecc mode, soft by default.
   Supported values are: "none", "soft", "hw", "hw_syndrome", "hw_oob_first",
   "soft_bch".
@@ -26,9 +29,18 @@
   are: 512, 1024.
 - atmel,pmecc-lookup-table-offset : includes two offsets of lookup table in ROM
   for different sector size. First one is for sector size 512, the next is for
-  sector size 1024.
+  sector size 1024. If not specified, driver will build the table in runtime.
 - nand-bus-width : 8 or 16 bus width if not present 8
 - nand-on-flash-bbt: boolean to enable on flash bbt option if not present false
+- Nand Flash Controller(NFC) is a slave driver under Atmel nand flash
+  - Required properties:
+    - compatible : "atmel,sama5d3-nfc".
+    - reg : should specify the address and size used for NFC command registers,
+            NFC registers and NFC Sram. NFC Sram address and size can be absent
+            if don't want to use it.
+    - clocks: phandle to the peripheral clock
+  - Optional properties:
+    - atmel,write-by-sram: boolean to enable NFC write by sram.
 
 Examples:
 nand0: nand@40000000,0 {
@@ -77,3 +89,23 @@
 		...
 	};
 };
+
+/* for NFC supported chips */
+nand0: nand@40000000 {
+	compatible = "atmel,at91rm9200-nand";
+	#address-cells = <1>;
+	#size-cells = <1>;
+	ranges;
+        ...
+        nfc@70000000 {
+		compatible = "atmel,sama5d3-nfc";
+		#address-cells = <1>;
+		#size-cells = <1>;
+		clocks = <&hsmc_clk>
+		reg = <
+			0x70000000 0x10000000	/* NFC Command Registers */
+			0xffffc000 0x00000070	/* NFC HSMC regs */
+			0x00200000 0x00100000	/* NFC SRAM banks */
+		>;
+	};
+};