--- zzzz-none-000/linux-3.10.107/Documentation/devicetree/bindings/net/fsl-fec.txt	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/Documentation/devicetree/bindings/net/fsl-fec.txt	2021-02-04 17:41:59.000000000 +0000
@@ -4,17 +4,30 @@
 - compatible : Should be "fsl,<soc>-fec"
 - reg : Address and length of the register set for the device
 - interrupts : Should contain fec interrupt
-- phy-mode : String, operation mode of the PHY interface.
-  Supported values are: "mii", "gmii", "sgmii", "tbi", "rmii",
-  "rgmii", "rgmii-id", "rgmii-rxid", "rgmii-txid", "rtbi", "smii".
+- phy-mode : See ethernet.txt file in the same directory
 
 Optional properties:
-- local-mac-address : 6 bytes, mac address
 - phy-reset-gpios : Should specify the gpio for phy reset
 - phy-reset-duration : Reset duration in milliseconds.  Should present
   only if property "phy-reset-gpios" is available.  Missing the property
   will have the duration be 1 millisecond.  Numbers greater than 1000 are
   invalid and 1 millisecond will be used instead.
+- phy-supply : regulator that powers the Ethernet PHY.
+- phy-handle : phandle to the PHY device connected to this device.
+- fixed-link : Assume a fixed link. See fixed-link.txt in the same directory.
+  Use instead of phy-handle.
+- fsl,num-tx-queues : The property is valid for enet-avb IP, which supports
+  hw multi queues. Should specify the tx queue number, otherwise set tx queue
+  number to 1.
+- fsl,num-rx-queues : The property is valid for enet-avb IP, which supports
+  hw multi queues. Should specify the rx queue number, otherwise set rx queue
+  number to 1.
+- fsl,magic-packet : If present, indicates that the hardware supports waking
+  up via magic packet.
+
+Optional subnodes:
+- mdio : specifies the mdio bus in the FEC, used as a container for phy nodes
+  according to phy.txt in the same directory
 
 Example:
 
@@ -25,4 +38,25 @@
 	phy-mode = "mii";
 	phy-reset-gpios = <&gpio2 14 0>; /* GPIO2_14 */
 	local-mac-address = [00 04 9F 01 1B B9];
+	phy-supply = <&reg_fec_supply>;
+};
+
+Example with phy specified:
+
+ethernet@83fec000 {
+	compatible = "fsl,imx51-fec", "fsl,imx27-fec";
+	reg = <0x83fec000 0x4000>;
+	interrupts = <87>;
+	phy-mode = "mii";
+	phy-reset-gpios = <&gpio2 14 0>; /* GPIO2_14 */
+	local-mac-address = [00 04 9F 01 1B B9];
+	phy-supply = <&reg_fec_supply>;
+	phy-handle = <&ethphy>;
+	mdio {
+		ethphy: ethernet-phy@6 {
+			compatible = "ethernet-phy-ieee802.3-c22";
+			reg = <6>;
+			max-speed = <100>;
+		};
+	};
 };