--- zzzz-none-000/linux-3.10.107/Documentation/devicetree/bindings/regulator/regulator.txt	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/Documentation/devicetree/bindings/regulator/regulator.txt	2021-02-04 17:41:59.000000000 +0000
@@ -7,10 +7,43 @@
 - regulator-microvolt-offset: Offset applied to voltages to compensate for voltage drops
 - regulator-min-microamp: smallest current consumers may set
 - regulator-max-microamp: largest current consumers may set
+- regulator-input-current-limit-microamp: maximum input current regulator allows
 - regulator-always-on: boolean, regulator should never be disabled
 - regulator-boot-on: bootloader/firmware enabled regulator
+- regulator-allow-bypass: allow the regulator to go into bypass mode
+- regulator-allow-set-load: allow the regulator performance level to be configured
 - <name>-supply: phandle to the parent supply/regulator node
 - regulator-ramp-delay: ramp delay for regulator(in uV/uS)
+  For hardware which supports disabling ramp rate, it should be explicitly
+  initialised to zero (regulator-ramp-delay = <0>) for disabling ramp delay.
+- regulator-enable-ramp-delay: The time taken, in microseconds, for the supply
+  rail to reach the target voltage, plus/minus whatever tolerance the board
+  design requires. This property describes the total system ramp time
+  required due to the combination of internal ramping of the regulator itself,
+  and board design issues such as trace capacitance and load on the supply.
+- regulator-soft-start: Enable soft start so that voltage ramps slowly
+- regulator-state-mem sub-root node for Suspend-to-RAM mode
+  : suspend to memory, the device goes to sleep, but all data stored in memory,
+  only some external interrupt can wake the device.
+- regulator-state-disk sub-root node for Suspend-to-DISK mode
+  : suspend to disk, this state operates similarly to Suspend-to-RAM,
+  but includes a final step of writing memory contents to disk.
+- regulator-state-[mem/disk] node has following common properties:
+	- regulator-on-in-suspend: regulator should be on in suspend state.
+	- regulator-off-in-suspend: regulator should be off in suspend state.
+	- regulator-suspend-microvolt: regulator should be set to this voltage
+	  in suspend.
+	- regulator-mode: operating mode in the given suspend state.
+	  The set of possible operating modes depends on the capabilities of
+	  every hardware so the valid modes are documented on each regulator
+	  device tree binding document.
+- regulator-initial-mode: initial operating mode. The set of possible operating
+  modes depends on the capabilities of every hardware so each device binding
+  documentation explains which values the regulator supports.
+- regulator-system-load: Load in uA present on regulator that is not captured by
+  any consumer request.
+- regulator-pull-down: Enable pull down resistor when the regulator is disabled.
+- regulator-over-current-protection: Enable over current protection.
 
 Deprecated properties:
 - regulator-compatible: If a regulator chip contains multiple
@@ -26,6 +59,10 @@
 		regulator-max-microvolt = <2500000>;
 		regulator-always-on;
 		vin-supply = <&vin>;
+
+		regulator-state-mem {
+			regulator-on-in-suspend;
+		};
 	};
 
 Regulator Consumers: