--- zzzz-none-000/linux-3.10.107/Documentation/devicetree/bindings/usb/usb3503.txt	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/Documentation/devicetree/bindings/usb/usb3503.txt	2021-02-04 17:41:59.000000000 +0000
@@ -1,19 +1,35 @@
 SMSC USB3503 High-Speed Hub Controller
 
 Required properties:
-- compatible: Should be "smsc,usb3503".
-- reg: Specifies the i2c slave address, it should be 0x08.
+- compatible: Should be "smsc,usb3503" or "smsc,usb3503a".
+
+Optional properties:
+- reg: Specifies the i2c slave address, it is required and should be 0x08
+       if I2C is used.
 - connect-gpios: Should specify GPIO for connect.
+- disabled-ports: Should specify the ports unused.
+	'1' or '2' or '3' are available for this property to describe the port
+	number. 1~3 property values are possible to be described.
+	Do not describe this property if all ports have to be enabled.
 - intn-gpios: Should specify GPIO for interrupt.
 - reset-gpios: Should specify GPIO for reset.
 - initial-mode: Should specify initial mode.
                 (1 for HUB mode, 2 for STANDBY mode)
+- refclk: Clock used for driving REFCLK signal (optional, if not provided
+	the driver assumes that clock signal is always available, its
+	rate is specified by REF_SEL pins and a value from the primary
+	reference clock frequencies table is used)
+- refclk-frequency: Frequency of the REFCLK signal as defined by REF_SEL
+	pins (optional, if not provided, driver will not set rate of the
+	REFCLK signal and assume that a value from the primary reference
+	clock frequencies table is used)
 
 Examples:
 	usb3503@08 {
 		compatible = "smsc,usb3503";
 		reg = <0x08>;
 		connect-gpios = <&gpx3 0 1>;
+		disabled-ports = <2 3>;
 		intn-gpios = <&gpx3 4 1>;
 		reset-gpios = <&gpx3 5 1>;
 		initial-mode = <1>;