--- zzzz-none-000/linux-3.10.107/arch/arm/boot/dts/kirkwood-6281.dtsi	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/arch/arm/boot/dts/kirkwood-6281.dtsi	2021-02-04 17:41:59.000000000 +0000
@@ -1,15 +1,43 @@
 / {
+	mbus {
+		pciec: pcie-controller {
+			compatible = "marvell,kirkwood-pcie";
+			status = "disabled";
+			device_type = "pci";
+
+			#address-cells = <3>;
+			#size-cells = <2>;
+
+			bus-range = <0x00 0xff>;
+
+			ranges =
+			       <0x82000000 0 0x40000 MBUS_ID(0xf0, 0x01) 0x40000 0 0x00002000
+				0x82000000 0x1 0     MBUS_ID(0x04, 0xe8) 0       1 0 /* Port 0.0 MEM */
+				0x81000000 0x1 0     MBUS_ID(0x04, 0xe0) 0       1 0 /* Port 0.0 IO  */>;
+
+			pcie0: pcie@1,0 {
+				device_type = "pci";
+				assigned-addresses = <0x82000800 0 0x00040000 0 0x2000>;
+				reg = <0x0800 0 0 0 0>;
+				#address-cells = <3>;
+				#size-cells = <2>;
+				#interrupt-cells = <1>;
+				ranges = <0x82000000 0 0 0x82000000 0x1 0 1 0
+					  0x81000000 0 0 0x81000000 0x1 0 1 0>;
+				interrupt-map-mask = <0 0 0 0>;
+				interrupt-map = <0 0 0 0 &intc 9>;
+				marvell,pcie-port = <0>;
+				marvell,pcie-lane = <0>;
+				clocks = <&gate_clk 2>;
+				status = "disabled";
+			};
+		};
+	};
+
 	ocp@f1000000 {
-		pinctrl: pinctrl@10000 {
+		pinctrl: pin-controller@10000 {
 			compatible = "marvell,88f6281-pinctrl";
-			reg = <0x10000 0x20>;
 
-			pmx_nand: pmx-nand {
-				marvell,pins = "mpp0", "mpp1", "mpp2", "mpp3",
-					       "mpp4", "mpp5", "mpp18",
-					       "mpp19";
-				marvell,function = "nand";
-			};
 			pmx_sata0: pmx-sata0 {
 				marvell,pins = "mpp5", "mpp21", "mpp23";
 				marvell,function = "sata0";
@@ -18,27 +46,43 @@
 				marvell,pins = "mpp4", "mpp20", "mpp22";
 				marvell,function = "sata1";
 			};
-			pmx_spi: pmx-spi {
-				marvell,pins = "mpp0", "mpp1", "mpp2", "mpp3";
-				marvell,function = "spi";
-			};
-			pmx_twsi0: pmx-twsi0 {
-				marvell,pins = "mpp8", "mpp9";
-				marvell,function = "twsi0";
-			};
-			pmx_uart0: pmx-uart0 {
-				marvell,pins = "mpp10", "mpp11";
-				marvell,function = "uart0";
-			};
-			pmx_uart1: pmx-uart1 {
-				marvell,pins = "mpp13", "mpp14";
-				marvell,function = "uart1";
-			};
 			pmx_sdio: pmx-sdio {
 				marvell,pins = "mpp12", "mpp13", "mpp14",
 					       "mpp15", "mpp16", "mpp17";
 				marvell,function = "sdio";
 			};
 		};
+
+		rtc: rtc@10300 {
+			compatible = "marvell,kirkwood-rtc", "marvell,orion-rtc";
+			reg = <0x10300 0x20>;
+			interrupts = <53>;
+			clocks = <&gate_clk 7>;
+		};
+
+		sata: sata@80000 {
+			compatible = "marvell,orion-sata";
+			reg = <0x80000 0x5000>;
+			interrupts = <21>;
+			clocks = <&gate_clk 14>, <&gate_clk 15>;
+			clock-names = "0", "1";
+			phys = <&sata_phy0>, <&sata_phy1>;
+			phy-names = "port0", "port1";
+			status = "disabled";
+		};
+
+		sdio: mvsdio@90000 {
+			compatible = "marvell,orion-sdio";
+			reg = <0x90000 0x200>;
+			interrupts = <28>;
+			clocks = <&gate_clk 4>;
+			pinctrl-0 = <&pmx_sdio>;
+			pinctrl-names = "default";
+			bus-width = <4>;
+			cap-sdio-irq;
+			cap-sd-highspeed;
+			cap-mmc-highspeed;
+			status = "disabled";
+		};
 	};
 };