--- zzzz-none-000/linux-3.10.107/arch/arm/mach-omap2/gpmc.h 2017-06-27 09:49:32.000000000 +0000 +++ scorpion-7490-727/linux-3.10.107/arch/arm/mach-omap2/gpmc.h 2021-02-04 17:41:59.000000000 +0000 @@ -6,226 +6,9 @@ * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License version 2 as * published by the Free Software Foundation. + * + * Do not include this file in any new code, this will get removed + * once omap3 boots in device tree only mode. + * */ - -#ifndef __OMAP2_GPMC_H -#define __OMAP2_GPMC_H - -#include - -/* Maximum Number of Chip Selects */ -#define GPMC_CS_NUM 8 - -#define GPMC_CS_CONFIG1 0x00 -#define GPMC_CS_CONFIG2 0x04 -#define GPMC_CS_CONFIG3 0x08 -#define GPMC_CS_CONFIG4 0x0c -#define GPMC_CS_CONFIG5 0x10 -#define GPMC_CS_CONFIG6 0x14 -#define GPMC_CS_CONFIG7 0x18 -#define GPMC_CS_NAND_COMMAND 0x1c -#define GPMC_CS_NAND_ADDRESS 0x20 -#define GPMC_CS_NAND_DATA 0x24 - -/* Control Commands */ -#define GPMC_CONFIG_RDY_BSY 0x00000001 -#define GPMC_CONFIG_DEV_SIZE 0x00000002 -#define GPMC_CONFIG_DEV_TYPE 0x00000003 -#define GPMC_SET_IRQ_STATUS 0x00000004 -#define GPMC_CONFIG_WP 0x00000005 - -#define GPMC_ENABLE_IRQ 0x0000000d - -/* ECC commands */ -#define GPMC_ECC_READ 0 /* Reset Hardware ECC for read */ -#define GPMC_ECC_WRITE 1 /* Reset Hardware ECC for write */ -#define GPMC_ECC_READSYN 2 /* Reset before syndrom is read back */ - -#define GPMC_CONFIG1_WRAPBURST_SUPP (1 << 31) -#define GPMC_CONFIG1_READMULTIPLE_SUPP (1 << 30) -#define GPMC_CONFIG1_READTYPE_ASYNC (0 << 29) -#define GPMC_CONFIG1_READTYPE_SYNC (1 << 29) -#define GPMC_CONFIG1_WRITEMULTIPLE_SUPP (1 << 28) -#define GPMC_CONFIG1_WRITETYPE_ASYNC (0 << 27) -#define GPMC_CONFIG1_WRITETYPE_SYNC (1 << 27) -#define GPMC_CONFIG1_CLKACTIVATIONTIME(val) ((val & 3) << 25) -#define GPMC_CONFIG1_PAGE_LEN(val) ((val & 3) << 23) -#define GPMC_CONFIG1_WAIT_READ_MON (1 << 22) -#define GPMC_CONFIG1_WAIT_WRITE_MON (1 << 21) -#define GPMC_CONFIG1_WAIT_MON_IIME(val) ((val & 3) << 18) -#define GPMC_CONFIG1_WAIT_PIN_SEL(val) ((val & 3) << 16) -#define GPMC_CONFIG1_DEVICESIZE(val) ((val & 3) << 12) -#define GPMC_CONFIG1_DEVICESIZE_16 GPMC_CONFIG1_DEVICESIZE(1) -#define GPMC_CONFIG1_DEVICETYPE(val) ((val & 3) << 10) -#define GPMC_CONFIG1_DEVICETYPE_NOR GPMC_CONFIG1_DEVICETYPE(0) -#define GPMC_CONFIG1_MUXTYPE(val) ((val & 3) << 8) -#define GPMC_CONFIG1_TIME_PARA_GRAN (1 << 4) -#define GPMC_CONFIG1_FCLK_DIV(val) (val & 3) -#define GPMC_CONFIG1_FCLK_DIV2 (GPMC_CONFIG1_FCLK_DIV(1)) -#define GPMC_CONFIG1_FCLK_DIV3 (GPMC_CONFIG1_FCLK_DIV(2)) -#define GPMC_CONFIG1_FCLK_DIV4 (GPMC_CONFIG1_FCLK_DIV(3)) -#define GPMC_CONFIG7_CSVALID (1 << 6) - -#define GPMC_DEVICETYPE_NOR 0 -#define GPMC_DEVICETYPE_NAND 2 -#define GPMC_CONFIG_WRITEPROTECT 0x00000010 -#define WR_RD_PIN_MONITORING 0x00600000 -#define GPMC_IRQ_FIFOEVENTENABLE 0x01 -#define GPMC_IRQ_COUNT_EVENT 0x02 - -#define GPMC_BURST_4 4 /* 4 word burst */ -#define GPMC_BURST_8 8 /* 8 word burst */ -#define GPMC_BURST_16 16 /* 16 word burst */ -#define GPMC_DEVWIDTH_8BIT 1 /* 8-bit device width */ -#define GPMC_DEVWIDTH_16BIT 2 /* 16-bit device width */ -#define GPMC_MUX_AAD 1 /* Addr-Addr-Data multiplex */ -#define GPMC_MUX_AD 2 /* Addr-Data multiplex */ - -/* bool type time settings */ -struct gpmc_bool_timings { - bool cycle2cyclediffcsen; - bool cycle2cyclesamecsen; - bool we_extra_delay; - bool oe_extra_delay; - bool adv_extra_delay; - bool cs_extra_delay; - bool time_para_granularity; -}; - -/* - * Note that all values in this struct are in nanoseconds except sync_clk - * (which is in picoseconds), while the register values are in gpmc_fck cycles. - */ -struct gpmc_timings { - /* Minimum clock period for synchronous mode (in picoseconds) */ - u32 sync_clk; - - /* Chip-select signal timings corresponding to GPMC_CS_CONFIG2 */ - u32 cs_on; /* Assertion time */ - u32 cs_rd_off; /* Read deassertion time */ - u32 cs_wr_off; /* Write deassertion time */ - - /* ADV signal timings corresponding to GPMC_CONFIG3 */ - u32 adv_on; /* Assertion time */ - u32 adv_rd_off; /* Read deassertion time */ - u32 adv_wr_off; /* Write deassertion time */ - - /* WE signals timings corresponding to GPMC_CONFIG4 */ - u32 we_on; /* WE assertion time */ - u32 we_off; /* WE deassertion time */ - - /* OE signals timings corresponding to GPMC_CONFIG4 */ - u32 oe_on; /* OE assertion time */ - u32 oe_off; /* OE deassertion time */ - - /* Access time and cycle time timings corresponding to GPMC_CONFIG5 */ - u32 page_burst_access; /* Multiple access word delay */ - u32 access; /* Start-cycle to first data valid delay */ - u32 rd_cycle; /* Total read cycle time */ - u32 wr_cycle; /* Total write cycle time */ - - u32 bus_turnaround; - u32 cycle2cycle_delay; - - u32 wait_monitoring; - u32 clk_activation; - - /* The following are only on OMAP3430 */ - u32 wr_access; /* WRACCESSTIME */ - u32 wr_data_mux_bus; /* WRDATAONADMUXBUS */ - - struct gpmc_bool_timings bool_timings; -}; - -/* Device timings in picoseconds */ -struct gpmc_device_timings { - u32 t_ceasu; /* address setup to CS valid */ - u32 t_avdasu; /* address setup to ADV valid */ - /* XXX: try to combine t_avdp_r & t_avdp_w. Issue is - * of tusb using these timings even for sync whilst - * ideally for adv_rd/(wr)_off it should have considered - * t_avdh instead. This indirectly necessitates r/w - * variations of t_avdp as it is possible to have one - * sync & other async - */ - u32 t_avdp_r; /* ADV low time (what about t_cer ?) */ - u32 t_avdp_w; - u32 t_aavdh; /* address hold time */ - u32 t_oeasu; /* address setup to OE valid */ - u32 t_aa; /* access time from ADV assertion */ - u32 t_iaa; /* initial access time */ - u32 t_oe; /* access time from OE assertion */ - u32 t_ce; /* access time from CS asertion */ - u32 t_rd_cycle; /* read cycle time */ - u32 t_cez_r; /* read CS deassertion to high Z */ - u32 t_cez_w; /* write CS deassertion to high Z */ - u32 t_oez; /* OE deassertion to high Z */ - u32 t_weasu; /* address setup to WE valid */ - u32 t_wpl; /* write assertion time */ - u32 t_wph; /* write deassertion time */ - u32 t_wr_cycle; /* write cycle time */ - - u32 clk; - u32 t_bacc; /* burst access valid clock to output delay */ - u32 t_ces; /* CS setup time to clk */ - u32 t_avds; /* ADV setup time to clk */ - u32 t_avdh; /* ADV hold time from clk */ - u32 t_ach; /* address hold time from clk */ - u32 t_rdyo; /* clk to ready valid */ - - u32 t_ce_rdyz; /* XXX: description ?, or use t_cez instead */ - u32 t_ce_avd; /* CS on to ADV on delay */ - - /* XXX: check the possibility of combining - * cyc_aavhd_oe & cyc_aavdh_we - */ - u8 cyc_aavdh_oe;/* read address hold time in cycles */ - u8 cyc_aavdh_we;/* write address hold time in cycles */ - u8 cyc_oe; /* access time from OE assertion in cycles */ - u8 cyc_wpl; /* write deassertion time in cycles */ - u32 cyc_iaa; /* initial access time in cycles */ - - /* extra delays */ - bool ce_xdelay; - bool avd_xdelay; - bool oe_xdelay; - bool we_xdelay; -}; - -struct gpmc_settings { - bool burst_wrap; /* enables wrap bursting */ - bool burst_read; /* enables read page/burst mode */ - bool burst_write; /* enables write page/burst mode */ - bool device_nand; /* device is NAND */ - bool sync_read; /* enables synchronous reads */ - bool sync_write; /* enables synchronous writes */ - bool wait_on_read; /* monitor wait on reads */ - bool wait_on_write; /* monitor wait on writes */ - u32 burst_len; /* page/burst length */ - u32 device_width; /* device bus width (8 or 16 bit) */ - u32 mux_add_data; /* multiplex address & data */ - u32 wait_pin; /* wait-pin to be used */ -}; - -extern int gpmc_calc_timings(struct gpmc_timings *gpmc_t, - struct gpmc_settings *gpmc_s, - struct gpmc_device_timings *dev_t); - -extern void gpmc_update_nand_reg(struct gpmc_nand_regs *reg, int cs); -extern int gpmc_get_client_irq(unsigned irq_config); - -extern unsigned int gpmc_ticks_to_ns(unsigned int ticks); - -extern void gpmc_cs_write_reg(int cs, int idx, u32 val); -extern int gpmc_calc_divider(unsigned int sync_clk); -extern int gpmc_cs_set_timings(int cs, const struct gpmc_timings *t); -extern int gpmc_cs_program_settings(int cs, struct gpmc_settings *p); -extern int gpmc_cs_request(int cs, unsigned long size, unsigned long *base); -extern void gpmc_cs_free(int cs); -extern void omap3_gpmc_save_context(void); -extern void omap3_gpmc_restore_context(void); -extern int gpmc_configure(int cmd, int wval); -extern void gpmc_read_settings_dt(struct device_node *np, - struct gpmc_settings *p); - -#endif +#include