--- zzzz-none-000/linux-3.10.107/arch/arm/mach-omap2/twl-common.c 2017-06-27 09:49:32.000000000 +0000 +++ scorpion-7490-727/linux-3.10.107/arch/arm/mach-omap2/twl-common.c 2021-02-04 17:41:59.000000000 +0000 @@ -24,6 +24,7 @@ #include #include #include +#include #include #include @@ -65,19 +66,24 @@ omap_register_i2c_bus(bus, clkrate, &pmic_i2c_board_info, 1); } +#ifdef CONFIG_ARCH_OMAP4 void __init omap4_pmic_init(const char *pmic_type, struct twl4030_platform_data *pmic_data, struct i2c_board_info *devices, int nr_devices) { /* PMIC part*/ + unsigned int irq; + omap_mux_init_signal("sys_nirq1", OMAP_PIN_INPUT_PULLUP | OMAP_PIN_OFF_WAKEUPENABLE); omap_mux_init_signal("fref_clk0_out.sys_drm_msecure", OMAP_PIN_OUTPUT); - omap_pmic_init(1, 400, pmic_type, 7 + OMAP44XX_IRQ_GIC_START, pmic_data); + irq = omap4_xlate_irq(7 + OMAP44XX_IRQ_GIC_START); + omap_pmic_init(1, 400, pmic_type, irq, pmic_data); /* Register additional devices on i2c1 bus if needed */ if (devices) i2c_register_board_info(1, devices, nr_devices); } +#endif void __init omap_pmic_late_init(void) { @@ -91,7 +97,7 @@ #if defined(CONFIG_ARCH_OMAP3) static struct twl4030_usb_data omap3_usb_pdata = { - .usb_mode = T2_USB_MODE_ULPI, + .usb_mode = T2_USB_MODE_ULPI, }; static int omap3_batt_table[] = { @@ -140,6 +146,7 @@ static struct regulator_consumer_supply omap3_vpll2_supplies[] = { REGULATOR_SUPPLY("vdds_dsi", "omapdss"), + REGULATOR_SUPPLY("vdds_dsi", "omapdss_dpi.0"), REGULATOR_SUPPLY("vdds_dsi", "omapdss_dsi.0"), };