--- zzzz-none-000/linux-3.10.107/arch/arm/mach-ux500/board-mop500-regulators.c	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/arch/arm/mach-ux500/board-mop500-regulators.c	2021-02-04 17:41:59.000000000 +0000
@@ -30,20 +30,6 @@
        .consumer_supplies = gpio_en_3v3_consumers,
 };
 
-static struct regulator_consumer_supply sdi0_reg_consumers[] = {
-        REGULATOR_SUPPLY("vqmmc", "sdi0"),
-};
-
-struct regulator_init_data sdi0_reg_init_data = {
-        .constraints = {
-                .min_uV         = 1800000,
-                .max_uV         = 2900000,
-                .valid_ops_mask = REGULATOR_CHANGE_VOLTAGE|REGULATOR_CHANGE_STATUS,
-        },
-        .num_consumer_supplies  = ARRAY_SIZE(sdi0_reg_consumers),
-        .consumer_supplies      = sdi0_reg_consumers,
-};
-
 /*
  * TPS61052 regulator
  */
@@ -810,7 +796,7 @@
 	INIT_REGULATOR_REGISTER(AB8505_CTRLVAUX6,              0x00, 0x00),
 };
 
-struct regulator_init_data ab8505_regulators[AB8505_NUM_REGULATORS] = {
+static struct regulator_init_data ab8505_regulators[AB8505_NUM_REGULATORS] = {
 	/* supplies to the display/camera */
 	[AB8505_LDO_AUX1] = {
 		.constraints = {
@@ -999,7 +985,6 @@
 	.num_ext_regulator      = ARRAY_SIZE(ab8500_ext_regulators),
 };
 
-/* Use the AB8500 init settings for AB8505 as they are the same right now */
 struct ab8500_regulator_platform_data ab8505_regulator_plat_data = {
 	.reg_init               = ab8505_reg_init,
 	.num_reg_init           = ARRAY_SIZE(ab8505_reg_init),