--- zzzz-none-000/linux-3.10.107/arch/mips/cavium-octeon/Kconfig	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/arch/mips/cavium-octeon/Kconfig	2021-02-04 17:41:59.000000000 +0000
@@ -1,7 +1,7 @@
 if CPU_CAVIUM_OCTEON
 
 config CAVIUM_CN63XXP1
-	bool "Enable CN63XXP1 errata worarounds"
+	bool "Enable CN63XXP1 errata workarounds"
 	default "n"
 	help
 	  The CN63XXP1 chip requires build time workarounds to
@@ -10,26 +10,6 @@
 	  non-CN63XXP1 hardware, so it is recommended to select "n"
 	  unless it is known the workarounds are needed.
 
-config CAVIUM_OCTEON_2ND_KERNEL
-	bool "Build the kernel to be used as a 2nd kernel on the same chip"
-	default "n"
-	help
-	  This option configures this kernel to be linked at a different
-	  address and use the 2nd uart for output. This allows a kernel built
-	  with this option to be run at the same time as one built without this
-	  option.
-
-config CAVIUM_OCTEON_HW_FIX_UNALIGNED
-	bool "Enable hardware fixups of unaligned loads and stores"
-	default "y"
-	help
-	  Configure the Octeon hardware to automatically fix unaligned loads
-	  and stores. Normally unaligned accesses are fixed using a kernel
-	  exception handler. This option enables the hardware automatic fixups,
-	  which requires only an extra 3 cycles. Disable this option if you
-	  are running code that relies on address exceptions on unaligned
-	  accesses.
-
 config CAVIUM_OCTEON_CVMSEG_SIZE
 	int "Number of L1 cache lines reserved for CVMSEG memory"
 	range 0 54
@@ -41,6 +21,19 @@
 	  legally range is from zero to 54 cache blocks (i.e. CVMSEG LM is
 	  between zero and 6192 bytes).
 
+endif # CPU_CAVIUM_OCTEON
+
+if CAVIUM_OCTEON_SOC
+
+config CAVIUM_OCTEON_2ND_KERNEL
+	bool "Build the kernel to be used as a 2nd kernel on the same chip"
+	default "n"
+	help
+	  This option configures this kernel to be linked at a different
+	  address and use the 2nd uart for output. This allows a kernel built
+	  with this option to be run at the same time as one built without this
+	  option.
+
 config CAVIUM_OCTEON_LOCK_L2
 	bool "Lock often used kernel code in the L2"
 	default "y"
@@ -93,7 +86,6 @@
 	select IOMMU_HELPER
 	select NEED_SG_DMA_LENGTH
 
-
 config OCTEON_ILM
 	tristate "Module to measure interrupt latency using Octeon CIU Timer"
 	help
@@ -103,4 +95,4 @@
 	  To compile this driver as a module, choose M here.  The module
 	  will be called octeon-ilm
 
-endif # CPU_CAVIUM_OCTEON
+endif # CAVIUM_OCTEON_SOC