--- zzzz-none-000/linux-3.10.107/arch/x86/kernel/head_32.S	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/arch/x86/kernel/head_32.S	2021-02-04 17:41:59.000000000 +0000
@@ -22,6 +22,7 @@
 #include <asm/cpufeature.h>
 #include <asm/percpu.h>
 #include <asm/nops.h>
+#include <asm/bootparam.h>
 
 /* Physical address */
 #define pa(X) ((X) - __PAGE_OFFSET)
@@ -61,9 +62,16 @@
 #define PAGE_TABLE_SIZE(pages) ((pages) / PTRS_PER_PGD)
 #endif
 
-/* Number of possible pages in the lowmem region */
-LOWMEM_PAGES = (((1<<32) - __PAGE_OFFSET) >> PAGE_SHIFT)
-	
+/*
+ * Number of possible pages in the lowmem region.
+ *
+ * We shift 2 by 31 instead of 1 by 32 to the left in order to avoid a
+ * gas warning about overflowing shift count when gas has been compiled
+ * with only a host target support using a 32-bit type for internal
+ * representation.
+ */
+LOWMEM_PAGES = (((2<<31) - __PAGE_OFFSET) >> PAGE_SHIFT)
+
 /* Enough space to fit pagetables for the low memory linear map */
 MAPPING_BEYOND_END = PAGE_TABLE_SIZE(LOWMEM_PAGES) << PAGE_SHIFT
 
@@ -90,7 +98,7 @@
 	
 	/* test KEEP_SEGMENTS flag to see if the bootloader is asking
 		us to not reload segments */
-	testb $(1<<6), BP_loadflags(%esi)
+	testb $KEEP_SEGMENTS, BP_loadflags(%esi)
 	jnz 2f
 
 /*
@@ -144,7 +152,7 @@
 	movl %eax, pa(olpc_ofw_pgd)
 #endif
 
-#ifdef CONFIG_MICROCODE_EARLY
+#ifdef CONFIG_MICROCODE
 	/* Early load ucode on BSP. */
 	call load_ucode_bsp
 #endif
@@ -292,7 +300,6 @@
  * If cpu hotplug is not supported then this code can go in init section
  * which will be freed later
  */
-__CPUINIT
 ENTRY(startup_32_smp)
 	cld
 	movl $(__BOOT_DS),%eax
@@ -304,12 +311,11 @@
 	movl %eax,%ss
 	leal -__PAGE_OFFSET(%ecx),%esp
 
-#ifdef CONFIG_MICROCODE_EARLY
+#ifdef CONFIG_MICROCODE
 	/* Early load ucode on AP. */
 	call load_ucode_ap
 #endif
 
-
 default_entry:
 #define CR0_STATE	(X86_CR0_PE | X86_CR0_MP | X86_CR0_ET | \
 			 X86_CR0_NE | X86_CR0_WP | X86_CR0_AM | \
@@ -410,6 +416,7 @@
 /*
  * Check if it is 486
  */
+	movb $4,X86			# at least 486
 	cmpl $-1,X86_CPUID
 	je is486
 
@@ -437,14 +444,12 @@
 	movl %edx,X86_CAPABILITY
 
 is486:
-	movb $4,X86
 	movl $0x50022,%ecx	# set AM, WP, NE and MP
 	movl %cr0,%eax
 	andl $0x80000011,%eax	# Save PG,PE,ET
 	orl %ecx,%eax
 	movl %eax,%cr0
 
-	call check_x87
 	lgdt early_gdt_descr
 	lidt idt_descr
 	ljmp $(__KERNEL_CS),$1f
@@ -467,26 +472,6 @@
 	pushl $0		# fake return address for unwinder
 	jmp *(initial_code)
 
-/*
- * We depend on ET to be correct. This checks for 287/387.
- */
-check_x87:
-	movb $0,X86_HARD_MATH
-	clts
-	fninit
-	fstsw %ax
-	cmpb $0,%al
-	je 1f
-	movl %cr0,%eax		/* no coprocessor: have to set bits */
-	xorl $4,%eax		/* set EM */
-	movl %eax,%cr0
-	ret
-	ALIGN
-1:	movb $1,X86_HARD_MATH
-	.byte 0xDB,0xE4		/* fsetpm for 287, ignored by 387 */
-	ret
-
-	
 #include "verify_cpu.S"
 
 /*
@@ -571,7 +556,7 @@
 	cld
 
 	cmpl $2,(%esp)		# X86_TRAP_NMI
-	je is_nmi		# Ignore NMI
+	je .Lis_nmi		# Ignore NMI
 
 	cmpl $2,%ss:early_recursion_flag
 	je hlt_loop
@@ -624,7 +609,7 @@
 	pop %ecx
 	pop %eax
 	decl %ss:early_recursion_flag
-is_nmi:
+.Lis_nmi:
 	addl $8,%esp		/* drop vector number and error code */
 	iret
 ENDPROC(early_idt_handler_common)