--- zzzz-none-000/linux-3.10.107/drivers/memory/Kconfig	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/drivers/memory/Kconfig	2021-02-04 17:41:59.000000000 +0000
@@ -7,6 +7,35 @@
 
 if MEMORY
 
+config ARM_PL172_MPMC
+	tristate "ARM PL172 MPMC driver"
+	depends on ARM_AMBA && OF
+	help
+	  This selects the ARM PrimeCell PL172 MultiPort Memory Controller.
+	  If you have an embedded system with an AMBA bus and a PL172
+	  controller, say Y or M here.
+
+config ATMEL_SDRAMC
+	bool "Atmel (Multi-port DDR-)SDRAM Controller"
+	default y
+	depends on ARCH_AT91 && OF
+	help
+	  This driver is for Atmel SDRAM Controller or Atmel Multi-port
+	  DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs.
+	  Starting with the at91sam9g45, this controller supports SDR, DDR and
+	  LP-DDR memories.
+
+config TI_AEMIF
+	tristate "Texas Instruments AEMIF driver"
+	depends on (ARCH_DAVINCI || ARCH_KEYSTONE) && OF
+	help
+	  This driver is for the AEMIF module available in Texas Instruments
+	  SoCs. AEMIF stands for Asynchronous External Memory Interface and
+	  is intended to provide a glue-less interface to a variety of
+	  asynchronuous memory devices like ASRAM, NOR and NAND memory. A total
+	  of 256M bytes of any of these memories can be accessed at a given
+	  time via four chip selects with 64M byte access per chip select.
+
 config TI_EMIF
 	tristate "Texas Instruments EMIF driver"
 	depends on ARCH_OMAP2PLUS
@@ -20,6 +49,38 @@
 	  parameters and other settings during frequency, voltage and
 	  temperature changes
 
+config OMAP_GPMC
+	bool
+	help
+	  This driver is for the General Purpose Memory Controller (GPMC)
+	  present on Texas Instruments SoCs (e.g. OMAP2+). GPMC allows
+	  interfacing to a variety of asynchronous as well as synchronous
+	  memory drives like NOR, NAND, OneNAND, SRAM.
+
+config OMAP_GPMC_DEBUG
+	bool "Enable GPMC debug output and skip reset of GPMC during init"
+	depends on OMAP_GPMC
+	help
+	  Enables verbose debugging mostly to decode the bootloader provided
+	  timings. To preserve the bootloader provided timings, the reset
+	  of GPMC is skipped during init. Enable this during development to
+	  configure devices connected to the GPMC bus.
+
+	  NOTE: In addition to matching the register setup with the bootloader
+	  you also need to match the GPMC FCLK frequency used by the
+	  bootloader or else the GPMC timings won't be identical with the
+	  bootloader timings.
+
+config MVEBU_DEVBUS
+	bool "Marvell EBU Device Bus Controller"
+	default y
+	depends on PLAT_ORION && OF
+	help
+	  This driver is for the Device Bus controller available in some
+	  Marvell EBU SoCs such as Discovery (mv78xx0), Orion (88f5xxx) and
+	  Armada 370 and Armada XP. This controller allows to handle flash
+	  devices such as NOR, NAND, SRAM, and FPGA.
+
 config TEGRA20_MC
 	bool "Tegra20 Memory Controller(MC) driver"
 	default y
@@ -30,14 +91,29 @@
 	  analysis, especially for IOMMU/GART(Graphics Address
 	  Relocation Table) module.
 
-config TEGRA30_MC
-	bool "Tegra30 Memory Controller(MC) driver"
+config FSL_CORENET_CF
+	tristate "Freescale CoreNet Error Reporting"
+	depends on FSL_SOC_BOOKE
+	help
+	  Say Y for reporting of errors from the Freescale CoreNet
+	  Coherency Fabric.  Errors reported include accesses to
+	  physical addresses that mapped by no local access window
+	  (LAW) or an invalid LAW, as well as bad cache state that
+	  represents a coherency violation.
+
+config FSL_IFC
+	bool
+	depends on FSL_SOC
+
+config JZ4780_NEMC
+	bool "Ingenic JZ4780 SoC NEMC driver"
 	default y
-	depends on ARCH_TEGRA_3x_SOC
+	depends on MACH_JZ4780
 	help
-	  This driver is for the Memory Controller(MC) module available
-	  in Tegra30 SoCs, mainly for a address translation fault
-	  analysis, especially for IOMMU/SMMU(System Memory Management
-	  Unit) module.
+	  This driver is for the NAND/External Memory Controller (NEMC) in
+	  the Ingenic JZ4780. This controller is used to handle external
+	  memory devices such as NAND and SRAM.
+
+source "drivers/memory/tegra/Kconfig"
 
 endif