--- zzzz-none-000/linux-3.10.107/drivers/net/ethernet/8390/ne2k-pci.c 2017-06-27 09:49:32.000000000 +0000 +++ scorpion-7490-727/linux-3.10.107/drivers/net/ethernet/8390/ne2k-pci.c 2021-02-04 17:41:59.000000000 +0000 @@ -33,8 +33,6 @@ /* The user-configurable values. These may be modified when a driver module is loaded.*/ -static int debug = 1; /* 1 normal messages, 0 quiet .. 7 verbose. */ - #define MAX_UNITS 8 /* More are supported, limit only on options */ /* Used to pass the full-duplex flag, etc. */ static int full_duplex[MAX_UNITS]; @@ -60,6 +58,8 @@ #include "8390.h" +static u32 ne2k_msg_enable; + /* These identify the driver base version and may not be removed. */ static const char version[] = KERN_INFO DRV_NAME ".c:v" DRV_VERSION " " DRV_RELDATE @@ -76,10 +76,10 @@ MODULE_DESCRIPTION("PCI NE2000 clone driver"); MODULE_LICENSE("GPL"); -module_param(debug, int, 0); +module_param_named(msg_enable, ne2k_msg_enable, uint, (S_IRUSR|S_IRGRP|S_IROTH)); module_param_array(options, int, NULL, 0); module_param_array(full_duplex, int, NULL, 0); -MODULE_PARM_DESC(debug, "debug level (1-2)"); +MODULE_PARM_DESC(msg_enable, "Debug message level (see linux/netdevice.h for bitmap)"); MODULE_PARM_DESC(options, "Bit 5: full duplex"); MODULE_PARM_DESC(full_duplex, "full duplex setting(s) (1)"); @@ -135,7 +135,7 @@ }; -static DEFINE_PCI_DEVICE_TABLE(ne2k_pci_tbl) = { +static const struct pci_device_id ne2k_pci_tbl[] = { { 0x10ec, 0x8029, PCI_ANY_ID, PCI_ANY_ID, 0, 0, CH_RealTek_RTL_8029 }, { 0x1050, 0x0940, PCI_ANY_ID, PCI_ANY_ID, 0, 0, CH_Winbond_89C940 }, { 0x11f6, 0x1401, PCI_ANY_ID, PCI_ANY_ID, 0, 0, CH_Compex_RL2000 }, @@ -226,6 +226,7 @@ static unsigned int fnd_cnt; long ioaddr; int flags = pci_clone_list[chip_idx].flags; + struct ei_device *ei_local; /* when built into the kernel, we only print version if device is found */ #ifndef MODULE @@ -245,13 +246,13 @@ if (!ioaddr || ((pci_resource_flags (pdev, 0) & IORESOURCE_IO) == 0)) { dev_err(&pdev->dev, "no I/O resource at PCI BAR #0\n"); - return -ENODEV; + goto err_out; } if (request_region (ioaddr, NE_IO_EXTENT, DRV_NAME) == NULL) { dev_err(&pdev->dev, "I/O resource 0x%x @ 0x%lx busy\n", NE_IO_EXTENT, ioaddr); - return -EBUSY; + goto err_out; } reg0 = inb(ioaddr); @@ -280,6 +281,8 @@ goto err_out_free_res; } dev->netdev_ops = &ne2k_netdev_ops; + ei_local = netdev_priv(dev); + ei_local->msg_enable = ne2k_msg_enable; SET_NETDEV_DEV(dev, &pdev->dev); @@ -379,9 +382,9 @@ if (i) goto err_out_free_netdev; - printk("%s: %s found at %#lx, IRQ %d, %pM.\n", - dev->name, pci_clone_list[chip_idx].name, ioaddr, dev->irq, - dev->dev_addr); + netdev_info(dev, "%s found at %#lx, IRQ %d, %pM.\n", + pci_clone_list[chip_idx].name, ioaddr, dev->irq, + dev->dev_addr); return 0; @@ -389,9 +392,9 @@ free_netdev (dev); err_out_free_res: release_region (ioaddr, NE_IO_EXTENT); - pci_set_drvdata (pdev, NULL); +err_out: + pci_disable_device(pdev); return -ENODEV; - } /* @@ -452,9 +455,10 @@ static void ne2k_pci_reset_8390(struct net_device *dev) { unsigned long reset_start_time = jiffies; + struct ei_device *ei_local = netdev_priv(dev); - if (debug > 1) printk("%s: Resetting the 8390 t=%ld...", - dev->name, jiffies); + netif_dbg(ei_local, hw, dev, "resetting the 8390 t=%ld...\n", + jiffies); outb(inb(NE_BASE + NE_RESET), NE_BASE + NE_RESET); @@ -464,7 +468,7 @@ /* This check _should_not_ be necessary, omit eventually. */ while ((inb(NE_BASE+EN0_ISR) & ENISR_RESET) == 0) if (jiffies - reset_start_time > 2) { - printk("%s: ne2k_pci_reset_8390() did not complete.\n", dev->name); + netdev_err(dev, "ne2k_pci_reset_8390() did not complete.\n"); break; } outb(ENISR_RESET, NE_BASE + EN0_ISR); /* Ack intr. */ @@ -481,9 +485,9 @@ /* This *shouldn't* happen. If it does, it's the last thing you'll see */ if (ei_status.dmaing) { - printk("%s: DMAing conflict in ne2k_pci_get_8390_hdr " + netdev_err(dev, "DMAing conflict in ne2k_pci_get_8390_hdr " "[DMAstat:%d][irqlock:%d].\n", - dev->name, ei_status.dmaing, ei_status.irqlock); + ei_status.dmaing, ei_status.irqlock); return; } @@ -519,9 +523,9 @@ /* This *shouldn't* happen. If it does, it's the last thing you'll see */ if (ei_status.dmaing) { - printk("%s: DMAing conflict in ne2k_pci_block_input " + netdev_err(dev, "DMAing conflict in ne2k_pci_block_input " "[DMAstat:%d][irqlock:%d].\n", - dev->name, ei_status.dmaing, ei_status.irqlock); + ei_status.dmaing, ei_status.irqlock); return; } ei_status.dmaing |= 0x01; @@ -574,9 +578,9 @@ /* This *shouldn't* happen. If it does, it's the last thing you'll see */ if (ei_status.dmaing) { - printk("%s: DMAing conflict in ne2k_pci_block_output." + netdev_err(dev, "DMAing conflict in ne2k_pci_block_output." "[DMAstat:%d][irqlock:%d]\n", - dev->name, ei_status.dmaing, ei_status.irqlock); + ei_status.dmaing, ei_status.irqlock); return; } ei_status.dmaing |= 0x01; @@ -621,7 +625,7 @@ while ((inb(nic_base + EN0_ISR) & ENISR_RDC) == 0) if (jiffies - dma_start > 2) { /* Avoid clock roll-over. */ - printk(KERN_WARNING "%s: timeout waiting for Tx RDC.\n", dev->name); + netdev_warn(dev, "timeout waiting for Tx RDC.\n"); ne2k_pci_reset_8390(dev); NS8390_init(dev,1); break; @@ -642,8 +646,24 @@ strlcpy(info->bus_info, pci_name(pci_dev), sizeof(info->bus_info)); } +static u32 ne2k_pci_get_msglevel(struct net_device *dev) +{ + struct ei_device *ei_local = netdev_priv(dev); + + return ei_local->msg_enable; +} + +static void ne2k_pci_set_msglevel(struct net_device *dev, u32 v) +{ + struct ei_device *ei_local = netdev_priv(dev); + + ei_local->msg_enable = v; +} + static const struct ethtool_ops ne2k_pci_ethtool_ops = { .get_drvinfo = ne2k_pci_get_drvinfo, + .get_msglevel = ne2k_pci_get_msglevel, + .set_msglevel = ne2k_pci_set_msglevel, }; static void ne2k_pci_remove_one(struct pci_dev *pdev) @@ -655,7 +675,6 @@ release_region(dev->base_addr, NE_IO_EXTENT); free_netdev(dev); pci_disable_device(pdev); - pci_set_drvdata(pdev, NULL); } #ifdef CONFIG_PM @@ -676,7 +695,7 @@ struct net_device *dev = pci_get_drvdata (pdev); int rc; - pci_set_power_state(pdev, 0); + pci_set_power_state(pdev, PCI_D0); pci_restore_state(pdev); rc = pci_enable_device(pdev);