--- zzzz-none-000/linux-3.10.107/drivers/net/ethernet/dec/tulip/tulip_core.c	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/drivers/net/ethernet/dec/tulip/tulip_core.c	2021-02-04 17:41:59.000000000 +0000
@@ -98,8 +98,7 @@
 #elif defined(__mips__)
 static int csr0 = 0x00200000 | 0x4000;
 #else
-#warning Processor architecture undefined!
-static int csr0 = 0x00A00000 | 0x4800;
+static int csr0;
 #endif
 
 /* Operational parameters that usually are not changed. */
@@ -207,7 +206,7 @@
 };
 
 
-static DEFINE_PCI_DEVICE_TABLE(tulip_pci_tbl) = {
+static const struct pci_device_id tulip_pci_tbl[] = {
 	{ 0x1011, 0x0009, PCI_ANY_ID, PCI_ANY_ID, 0, 0, DC21140 },
 	{ 0x1011, 0x0019, PCI_ANY_ID, PCI_ANY_ID, 0, 0, DC21143 },
 	{ 0x11AD, 0x0002, PCI_ANY_ID, PCI_ANY_ID, 0, 0, LC82C168 },
@@ -589,7 +588,7 @@
 			       (unsigned int)tp->rx_ring[i].buffer1,
 			       (unsigned int)tp->rx_ring[i].buffer2,
 			       buf[0], buf[1], buf[2]);
-			for (j = 0; buf[j] != 0xee && j < 1600; j++)
+			for (j = 0; ((j < 1600) && buf[j] != 0xee); j++)
 				if (j < 100)
 					pr_cont(" %02x", buf[j]);
 			pr_cont(" j=%d\n", j);
@@ -1294,7 +1293,7 @@
 #endif
 };
 
-DEFINE_PCI_DEVICE_TABLE(early_486_chipsets) = {
+const struct pci_device_id early_486_chipsets[] = {
 	{ PCI_DEVICE(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82424) },
 	{ PCI_DEVICE(PCI_VENDOR_ID_SI, PCI_DEVICE_ID_SI_496) },
 	{ },
@@ -1304,7 +1303,9 @@
 {
 	struct tulip_private *tp;
 	/* See note below on the multiport cards. */
-	static unsigned char last_phys_addr[6] = {0x00, 'L', 'i', 'n', 'u', 'x'};
+	static unsigned char last_phys_addr[ETH_ALEN] = {
+		0x00, 'L', 'i', 'n', 'u', 'x'
+	};
 	static int last_irq;
 	static int multiport_cnt;	/* For four-port boards w/one EEPROM */
 	int i, irq;
@@ -1410,12 +1411,6 @@
 		return i;
 	}
 
-	/* The chip will fail to enter a low-power state later unless
-	 * first explicitly commanded into D0 */
-	if (pci_set_power_state(pdev, PCI_D0)) {
-		pr_notice("Failed to set power state to D0\n");
-	}
-
 	irq = pdev->irq;
 
 	/* alloc_etherdev ensures aligned and zeroed private structures */
@@ -1633,8 +1628,8 @@
 		dev->dev_addr[i] = last_phys_addr[i] + 1;
 #if defined(CONFIG_SPARC)
 		addr = of_get_property(dp, "local-mac-address", &len);
-		if (addr && len == 6)
-			memcpy(dev->dev_addr, addr, 6);
+		if (addr && len == ETH_ALEN)
+			memcpy(dev->dev_addr, addr, ETH_ALEN);
 #endif
 #if defined(__i386__) || defined(__x86_64__)	/* Patch up x86 BIOS bug. */
 		if (last_irq)
@@ -1707,7 +1702,7 @@
 #ifdef CONFIG_TULIP_NAPI
 	netif_napi_add(dev, &tp->napi, tulip_poll, 16);
 #endif
-	SET_ETHTOOL_OPS(dev, &ops);
+	dev->ethtool_ops = &ops;
 
 	if (register_netdev(dev))
 		goto err_out_free_ring;
@@ -1943,7 +1938,7 @@
 	pci_iounmap(pdev, tp->base_addr);
 	free_netdev (dev);
 	pci_release_regions (pdev);
-	pci_set_drvdata (pdev, NULL);
+	pci_disable_device(pdev);
 
 	/* pci_power_off (pdev, -1); */
 }
@@ -1986,6 +1981,12 @@
 	pr_info("%s", version);
 #endif
 
+	if (!csr0) {
+		pr_warn("tulip: unknown CPU architecture, using default csr0\n");
+		/* default to 8 longword cache line alignment */
+		csr0 = 0x00A00000 | 0x4800;
+	}
+
 	/* copy module parms into globals */
 	tulip_rx_copybreak = rx_copybreak;
 	tulip_max_interrupt_work = max_interrupt_work;