--- zzzz-none-000/linux-3.10.107/drivers/net/ethernet/qlogic/Kconfig	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/drivers/net/ethernet/qlogic/Kconfig	2021-02-04 17:41:59.000000000 +0000
@@ -7,9 +7,7 @@
 	default y
 	depends on PCI
 	---help---
-	  If you have a network (Ethernet) card belonging to this class, say Y
-	  and read the Ethernet-HOWTO, available from
-	  <http://www.tldp.org/docs.html#howto>.
+	  If you have a network (Ethernet) card belonging to this class, say Y.
 
 	  Note that the answer to this question doesn't directly affect the
 	  kernel: saying N will just cause the configurator to skip all
@@ -45,6 +43,38 @@
 	  This allows for virtual function acceleration in virtualized
 	  environments.
 
+config QLCNIC_DCB
+	bool "QLOGIC QLCNIC 82XX and 83XX family DCB Support"
+	depends on QLCNIC && DCB
+	default y
+	---help---
+	  This configuration parameter enables DCB support in QLE83XX
+	  and QLE82XX Converged Ethernet devices. This allows for DCB
+	  get operations support through rtNetlink interface. Only CEE
+	  mode of DCB is supported. PG and PFC values are related only
+	  to Tx.
+
+config QLCNIC_VXLAN
+	bool "Virtual eXtensible Local Area Network (VXLAN) offload support"
+	default n
+	depends on QLCNIC && VXLAN && !(QLCNIC=y && VXLAN=m)
+	---help---
+	  This enables hardware offload support for VXLAN protocol over QLogic's
+	  84XX series adapters.
+	  Say Y here if you want to enable hardware offload support for
+	  Virtual eXtensible Local Area Network (VXLAN) in the driver.
+
+config QLCNIC_HWMON
+	bool "QLOGIC QLCNIC 82XX and 83XX family HWMON support"
+	depends on QLCNIC && HWMON && !(QLCNIC=y && HWMON=m)
+	default y
+	---help---
+	  This configuration parameter can be used to read the
+	  board temperature in Converged Ethernet devices
+	  supported by qlcnic.
+
+	  This data is available via the hwmon sysfs interface.
+
 config QLGE
 	tristate "QLogic QLGE 10Gb Ethernet Driver Support"
 	depends on PCI
@@ -61,4 +91,16 @@
 	---help---
 	  This enables the support for NetXen's Gigabit Ethernet card.
 
+config QED
+	tristate "QLogic QED 25/40/100Gb core driver"
+	depends on PCI
+	select ZLIB_INFLATE
+	---help---
+	  This enables the support for ...
+
+config QEDE
+	tristate "QLogic QED 25/40/100Gb Ethernet NIC"
+	depends on QED
+	---help---
+	  This enables the support for ...
 endif # NET_VENDOR_QLOGIC