--- zzzz-none-000/linux-3.10.107/drivers/tty/serial/mux.c	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/drivers/tty/serial/mux.c	2021-02-04 17:41:59.000000000 +0000
@@ -29,7 +29,7 @@
 #include <asm/irq.h>
 #include <asm/parisc-device.h>
 
-#ifdef CONFIG_MAGIC_SYSRQ
+#if defined(CONFIG_SERIAL_MUX_CONSOLE) && defined(CONFIG_MAGIC_SYSRQ)
 #include <linux/sysrq.h>
 #define SUPPORT_SYSRQ
 #endif
@@ -169,16 +169,6 @@
 }
 
 /**
- * mux_enable_ms - Enable modum status interrupts.
- * @port: Ptr to the uart_port.
- *
- * The Serial Mux does not support this function.
- */
-static void mux_enable_ms(struct uart_port *port)
-{
-}
-
-/**
  * mux_break_ctl - Control the transmitssion of a break signal.
  * @port: Ptr to the uart_port.
  * @break_state: Raise/Lower the break signal.
@@ -422,19 +412,14 @@
         return 0;
 }
 
-struct tty_driver *mux_console_device(struct console *co, int *index)
-{
-        *index = co->index;
-	return mux_driver.tty_driver;
-}
-
 static struct console mux_console = {
 	.name =		"ttyB",
 	.write =	mux_console_write,
-	.device =	mux_console_device,
+	.device =	uart_console_device,
 	.setup =	mux_console_setup,
 	.flags =	CON_ENABLED | CON_PRINTBUFFER,
 	.index =	0,
+	.data =		&mux_driver,
 };
 
 #define MUX_CONSOLE	&mux_console
@@ -449,7 +434,6 @@
 	.stop_tx =		mux_stop_tx,
 	.start_tx =		mux_start_tx,
 	.stop_rx =		mux_stop_rx,
-	.enable_ms =		mux_enable_ms,
 	.break_ctl =		mux_break_ctl,
 	.startup =		mux_startup,
 	.shutdown =		mux_shutdown,
@@ -613,7 +597,7 @@
 {
 	/* Delete the Mux timer. */
 	if(port_cnt > 0) {
-		del_timer(&mux_timer);
+		del_timer_sync(&mux_timer);
 #ifdef CONFIG_SERIAL_MUX_CONSOLE
 		unregister_console(&mux_console);
 #endif