--- zzzz-none-000/linux-3.10.107/drivers/usb/chipidea/host.c 2017-06-27 09:49:32.000000000 +0000 +++ scorpion-7490-727/linux-3.10.107/drivers/usb/chipidea/host.c 2021-02-04 17:41:59.000000000 +0000 @@ -24,6 +24,7 @@ #include #include #include +#include #include "../host/ehci.h" @@ -32,16 +33,81 @@ #include "host.h" static struct hc_driver __read_mostly ci_ehci_hc_driver; +static int (*orig_bus_suspend)(struct usb_hcd *hcd); -static irqreturn_t host_irq(struct ci13xxx *ci) +struct ehci_ci_priv { + struct regulator *reg_vbus; +}; + +static int ehci_ci_portpower(struct usb_hcd *hcd, int portnum, bool enable) +{ + struct ehci_hcd *ehci = hcd_to_ehci(hcd); + struct ehci_ci_priv *priv = (struct ehci_ci_priv *)ehci->priv; + struct device *dev = hcd->self.controller; + struct ci_hdrc *ci = dev_get_drvdata(dev); + int ret = 0; + int port = HCS_N_PORTS(ehci->hcs_params); + + if (priv->reg_vbus) { + if (port > 1) { + dev_warn(dev, + "Not support multi-port regulator control\n"); + return 0; + } + if (enable) + ret = regulator_enable(priv->reg_vbus); + else + ret = regulator_disable(priv->reg_vbus); + if (ret) { + dev_err(dev, + "Failed to %s vbus regulator, ret=%d\n", + enable ? "enable" : "disable", ret); + return ret; + } + } + + if (enable && (ci->platdata->phy_mode == USBPHY_INTERFACE_MODE_HSIC)) { + /* + * Marvell 28nm HSIC PHY requires forcing the port to HS mode. + * As HSIC is always HS, this should be safe for others. + */ + hw_port_test_set(ci, 5); + hw_port_test_set(ci, 0); + } + return 0; +}; + +static int ehci_ci_reset(struct usb_hcd *hcd) +{ + struct device *dev = hcd->self.controller; + struct ci_hdrc *ci = dev_get_drvdata(dev); + int ret; + + ret = ehci_setup(hcd); + if (ret) + return ret; + + ci_platform_configure(ci); + + return ret; +} + +static const struct ehci_driver_overrides ehci_ci_overrides = { + .extra_priv_size = sizeof(struct ehci_ci_priv), + .port_power = ehci_ci_portpower, + .reset = ehci_ci_reset, +}; + +static irqreturn_t host_irq(struct ci_hdrc *ci) { return usb_hcd_irq(ci->irq, ci->hcd); } -static int host_start(struct ci13xxx *ci) +static int host_start(struct ci_hdrc *ci) { struct usb_hcd *hcd; struct ehci_hcd *ehci; + struct ehci_ci_priv *priv; int ret; if (usb_disabled()) @@ -58,33 +124,123 @@ hcd->has_tt = 1; hcd->power_budget = ci->platdata->power_budget; - hcd->phy = ci->transceiver; + hcd->tpl_support = ci->platdata->tpl_support; + if (ci->phy) + hcd->phy = ci->phy; + else + hcd->usb_phy = ci->usb_phy; ehci = hcd_to_ehci(hcd); ehci->caps = ci->hw_bank.cap; ehci->has_hostpc = ci->hw_bank.lpm; + ehci->has_tdi_phy_lpm = ci->hw_bank.lpm; + ehci->imx28_write_fix = ci->imx28_write_fix; + + priv = (struct ehci_ci_priv *)ehci->priv; + priv->reg_vbus = NULL; + + if (ci->platdata->reg_vbus && !ci_otg_is_fsm_mode(ci)) { + if (ci->platdata->flags & CI_HDRC_TURN_VBUS_EARLY_ON) { + ret = regulator_enable(ci->platdata->reg_vbus); + if (ret) { + dev_err(ci->dev, + "Failed to enable vbus regulator, ret=%d\n", + ret); + goto put_hcd; + } + } else { + priv->reg_vbus = ci->platdata->reg_vbus; + } + } ret = usb_add_hcd(hcd, 0, 0); - if (ret) - usb_put_hcd(hcd); - else + if (ret) { + goto disable_reg; + } else { + struct usb_otg *otg = &ci->otg; + ci->hcd = hcd; - if (ci->platdata->flags & CI13XXX_DISABLE_STREAMING) - hw_write(ci, OP_USBMODE, USBMODE_CI_SDIS, USBMODE_CI_SDIS); + if (ci_otg_is_fsm_mode(ci)) { + otg->host = &hcd->self; + hcd->self.otg_port = 1; + } + } + + return ret; + +disable_reg: + if (ci->platdata->reg_vbus && !ci_otg_is_fsm_mode(ci) && + (ci->platdata->flags & CI_HDRC_TURN_VBUS_EARLY_ON)) + regulator_disable(ci->platdata->reg_vbus); +put_hcd: + usb_put_hcd(hcd); return ret; } -static void host_stop(struct ci13xxx *ci) +static void host_stop(struct ci_hdrc *ci) { struct usb_hcd *hcd = ci->hcd; - usb_remove_hcd(hcd); - usb_put_hcd(hcd); + if (hcd) { + usb_remove_hcd(hcd); + usb_put_hcd(hcd); + if (ci->platdata->reg_vbus && !ci_otg_is_fsm_mode(ci) && + (ci->platdata->flags & CI_HDRC_TURN_VBUS_EARLY_ON)) + regulator_disable(ci->platdata->reg_vbus); + } +} + + +void ci_hdrc_host_destroy(struct ci_hdrc *ci) +{ + if (ci->role == CI_ROLE_HOST && ci->hcd) + host_stop(ci); +} + +static int ci_ehci_bus_suspend(struct usb_hcd *hcd) +{ + struct ehci_hcd *ehci = hcd_to_ehci(hcd); + int port; + u32 tmp; + + int ret = orig_bus_suspend(hcd); + + if (ret) + return ret; + + port = HCS_N_PORTS(ehci->hcs_params); + while (port--) { + u32 __iomem *reg = &ehci->regs->port_status[port]; + u32 portsc = ehci_readl(ehci, reg); + + if (portsc & PORT_CONNECT) { + /* + * For chipidea, the resume signal will be ended + * automatically, so for remote wakeup case, the + * usbcmd.rs may not be set before the resume has + * ended if other resume paths consumes too much + * time (~24ms), in that case, the SOF will not + * send out within 3ms after resume ends, then the + * high speed device will enter full speed mode. + */ + + tmp = ehci_readl(ehci, &ehci->regs->command); + tmp |= CMD_RUN; + ehci_writel(ehci, tmp, &ehci->regs->command); + /* + * It needs a short delay between set RS bit and PHCD. + */ + usleep_range(150, 200); + break; + } + } + + return 0; } -int ci_hdrc_host_init(struct ci13xxx *ci) +int ci_hdrc_host_init(struct ci_hdrc *ci) { struct ci_role_driver *rdrv; @@ -101,7 +257,12 @@ rdrv->name = "host"; ci->roles[CI_ROLE_HOST] = rdrv; - ehci_init_driver(&ci_ehci_hc_driver, NULL); - return 0; } + +void ci_hdrc_host_driver_init(void) +{ + ehci_init_driver(&ci_ehci_hc_driver, &ehci_ci_overrides); + orig_bus_suspend = ci_ehci_hc_driver.bus_suspend; + ci_ehci_hc_driver.bus_suspend = ci_ehci_bus_suspend; +}