--- zzzz-none-000/linux-3.10.107/drivers/w1/slaves/Kconfig	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/drivers/w1/slaves/Kconfig	2021-02-04 17:41:59.000000000 +0000
@@ -38,6 +38,14 @@
 	  Say Y here if you want to use a 1-wire
 	  DS2413 Dual Channel Addressable Switch device support
 
+config W1_SLAVE_DS2406
+	tristate "Dual Channel Addressable Switch 0x12 family support (DS2406)"
+	select CRC16
+	help
+	  Say Y or M here if you want to use a 1-wire
+	  DS2406 Dual Channel Addressable Switch.  EPROM read/write
+	  support for these devices is not implemented.
+
 config W1_SLAVE_DS2423
 	tristate "Counter 1-wire device (DS2423)"
 	select CRC16
@@ -72,7 +80,6 @@
 
 config W1_SLAVE_DS2760
 	tristate "Dallas 2760 battery monitor chip (HP iPAQ & others)"
-	depends on W1
 	help
 	  If you enable this you will have the DS2760 battery monitor
 	  chip support.
@@ -85,7 +92,6 @@
 
 config W1_SLAVE_DS2780
 	tristate "Dallas 2780 battery monitor chip"
-	depends on W1
 	help
 	  If you enable this you will have the DS2780 battery monitor
 	  chip support.
@@ -98,7 +104,6 @@
 
 config W1_SLAVE_DS2781
 	tristate "Dallas 2781 battery monitor chip"
-	depends on W1
 	help
 	  If you enable this you will have the DS2781 battery monitor
 	  chip support.
@@ -111,7 +116,6 @@
 
 config W1_SLAVE_DS28E04
 	tristate "4096-Bit Addressable 1-Wire EEPROM with PIO (DS28E04-100)"
-	depends on W1
 	select CRC16
 	help
 	  If you enable this you will have the DS28E04-100
@@ -124,7 +128,6 @@
 
 config W1_SLAVE_BQ27000
 	tristate "BQ27000 slave support"
-	depends on W1
 	help
 	  Say Y here if you want to use a hdq
 	  bq27000 slave support.