--- zzzz-none-000/linux-3.10.107/include/linux/regulator/machine.h	2017-06-27 09:49:32.000000000 +0000
+++ scorpion-7490-727/linux-3.10.107/include/linux/regulator/machine.h	2021-02-04 17:41:59.000000000 +0000
@@ -75,6 +75,8 @@
  *
  * @min_uA: Smallest current consumers may set.
  * @max_uA: Largest current consumers may set.
+ * @ilim_uA: Maximum input current.
+ * @system_load: Load that isn't captured by any consumer requests.
  *
  * @valid_modes_mask: Mask of modes which may be configured by consumers.
  * @valid_ops_mask: Operations which may be performed by consumers.
@@ -85,6 +87,9 @@
  *           bootloader then it will be enabled when the constraints are
  *           applied.
  * @apply_uV: Apply the voltage constraint when initialising.
+ * @ramp_disable: Disable ramp delay when initialising or when setting voltage.
+ * @soft_start: Enable soft start so that voltage ramps slowly.
+ * @pull_down: Enable pull down when regulator is disabled.
  *
  * @input_uV: Input voltage for regulator when supplied by another regulator.
  *
@@ -95,6 +100,7 @@
  * @initial_state: Suspend state to set by default.
  * @initial_mode: Mode to set at startup.
  * @ramp_delay: Time to settle down after voltage change (unit: uV/us)
+ * @enable_time: Turn-on time of the rails (unit: microseconds)
  */
 struct regulation_constraints {
 
@@ -109,6 +115,9 @@
 	/* current output range (inclusive) - for current control */
 	int min_uA;
 	int max_uA;
+	int ilim_uA;
+
+	int system_load;
 
 	/* valid regulator operating modes for this machine */
 	unsigned int valid_modes_mask;
@@ -129,11 +138,16 @@
 	unsigned int initial_mode;
 
 	unsigned int ramp_delay;
+	unsigned int enable_time;
 
 	/* constraint flags */
 	unsigned always_on:1;	/* regulator never off when system is on */
 	unsigned boot_on:1;	/* bootloader/firmware enabled regulator */
 	unsigned apply_uV:1;	/* apply uV constraint if min == max */
+	unsigned ramp_disable:1; /* disable ramp delay */
+	unsigned soft_start:1;	/* ramp voltage slowly */
+	unsigned pull_down:1;	/* pull down resistor when regulator off */
+	unsigned over_current_protection:1; /* auto disable on over current */
 };
 
 /**
@@ -187,19 +201,21 @@
 	void *driver_data;	/* core does not touch this */
 };
 
-int regulator_suspend_prepare(suspend_state_t state);
-int regulator_suspend_finish(void);
-
 #ifdef CONFIG_REGULATOR
 void regulator_has_full_constraints(void);
-void regulator_use_dummy_regulator(void);
+int regulator_suspend_prepare(suspend_state_t state);
+int regulator_suspend_finish(void);
 #else
 static inline void regulator_has_full_constraints(void)
 {
 }
-
-static inline void regulator_use_dummy_regulator(void)
+static inline int regulator_suspend_prepare(suspend_state_t state)
+{
+	return 0;
+}
+static inline int regulator_suspend_finish(void)
 {
+	return 0;
 }
 #endif