# # USB OTG infrastructure may be needed for peripheral-only, host-only, # or OTG-capable configurations when OTG transceivers or controllers # are used. # comment "OTG and related infrastructure" config USB_OTG_UTILS bool help Select this to make sure the build includes objects from the OTG infrastructure directory. if USB || USB_GADGET # # USB Transceiver Drivers # config USB_GPIO_VBUS tristate "GPIO based peripheral-only VBUS sensing 'transceiver'" depends on GENERIC_GPIO select USB_OTG_UTILS help Provides simple GPIO VBUS sensing for controllers with an internal transceiver via the otg_transceiver interface, and optionally control of a D+ pullup GPIO as well as a VBUS current limit regulator. config ISP1301_OMAP tristate "Philips ISP1301 with OMAP OTG" depends on I2C && ARCH_OMAP_OTG select USB_OTG_UTILS help If you say yes here you get support for the Philips ISP1301 USB-On-The-Go transceiver working with the OMAP OTG controller. The ISP1301 is a full speed USB transceiver which is used in products including H2, H3, and H4 development boards for Texas Instruments OMAP processors. This driver can also be built as a module. If so, the module will be called isp1301_omap. config TWL4030_USB tristate "TWL4030 USB Transceiver Driver" depends on TWL4030_CORE && REGULATOR_TWL4030 select USB_OTG_UTILS help Enable this to support the USB OTG transceiver on TWL4030 family chips (including the TWL5030 and TPS659x0 devices). This transceiver supports high and full speed devices plus, in host mode, low speed. config NOP_USB_XCEIV tristate "NOP USB Transceiver Driver" select USB_OTG_UTILS help this driver is to be used by all the usb transceiver which are either built-in with usb ip or which are autonomous and doesn't require any phy programming such as ISP1x04 etc. endif # USB || OTG