#include <linux/avm_hw_config_def.h>
#include "Fritz_Box_HW211.dts"

/ {

    avm-hw-revision{
        compatible = "avm,avm_hw_revision";
        revision = "211";
        subrevision = "2";
    };
    avm-gpio{
      compatible = "avm,avm_gpio_generic";
        gpio_avm_led_power{
            param = <AVM_DEF_HW_PARAM_GPIO_OUT_ACTIVE_HIGH>;
            value = <63>;
        };
        gpio_avm_led_wan{
            param = <AVM_DEF_HW_PARAM_GPIO_OUT_ACTIVE_HIGH>;
            value = <65>;
        };
        gpio_avm_led_wlan{
            param = <AVM_DEF_HW_PARAM_GPIO_OUT_ACTIVE_HIGH>;
            value = <68>;
        };
        gpio_avm_led_internet{
            param = <AVM_DEF_HW_PARAM_GPIO_OUT_ACTIVE_HIGH>;
            value = <64>;
        };
        gpio_avm_led_info{
            param = <AVM_DEF_HW_PARAM_GPIO_OUT_ACTIVE_HIGH>;
            value = <57>;
        };
        gpio_avm_led_info_red{
            param = <AVM_DEF_HW_PARAM_GPIO_OUT_ACTIVE_HIGH>;
            value = <26>;
        };
    };

	soc {


		mdio0: mdio {
			compatible = "virtual,mdio-gpio";
			#address-cells = <1>;
			#size-cells = <0>;
			gpios = <&qcom_pinmux 1 0 &qcom_pinmux 0 0>;

			phy0: ethernet-phy@0 {
				device_type = "ethernet-phy";
				reg = <0>;
				qca,ar8327-initvals = <
					0x00004 0x7600000   /* PAD0_MODE */
					0x00008 0x1000000   /* PAD5_MODE */
					0x0000c 0x80        /* PAD6_MODE */
					0x000e4 0xaa545     /* MAC_POWER_SEL */
					0x000e0 0xc74164de  /* SGMII_CTRL */
					0x0007c 0x4e        /* PORT0_STATUS */
					0x00094 0x4e        /* PORT6_STATUS */
				>;
			};

			phy4: ethernet-phy@4 {
				device_type = "ethernet-phy";
				reg = <4>;
			};
		};

		nss0: nss@40000000 {
			compatible = "qcom,nss0";
			interrupts = <GIC_SPI 213 IRQ_TYPE_LEVEL_HIGH
				      GIC_SPI 232 IRQ_TYPE_LEVEL_HIGH>;
			reg = <0x36000000 0x1000 0x39000000 0x20000>;
			reg-names = "nphys", "vphys";
			clocks = <&gcc NSS_CORE_CLK>, <&gcc NSSTCM_CLK_SRC>, <&gcc NSSTCM_CLK>;
			clock-names = "nss_core_clk", "nss_tcm_src", "nss_tcm_clk";
			resets = <&gcc UBI32_CORE1_CLKRST_CLAMP_RESET>,
				 <&gcc UBI32_CORE1_CLAMP_RESET>,
				 <&gcc UBI32_CORE1_AHB_RESET>,
				 <&gcc UBI32_CORE1_AXI_RESET>;
			reset-names = "clkrst_clamp", "clamp", "ahb", "axi";
			qcom,id = <0>;
			qcom,num_irq = <2>;
			qcom,rst_addr = <0x40000000>;
			qcom,load_addr = <0x40000000>;
			qcom,turbo_frequency = <0>;
			qcom,low_frequency = <110000000>;
			qcom,mid_frequency = <275000000>;
			qcom,max_frequency = <550000000>;
			qcom,ipv4_enabled = <1>;
			qcom,ipv6_enabled = <1>;
			qcom,l2switch_enabled = <1>;
			qcom,crypto_enabled = <0>;
			qcom,ipsec_enabled = <0>;
			qcom,wlan_enabled = <0>;
			qcom,tun6rd_enabled = <1>;
			qcom,tunipip6_enabled = <1>;
			qcom,shaping_enabled = <1>;
			qcom,gmac0_enabled = <1>;
			qcom,gmac1_enabled = <1>;
			qcom,gmac2_enabled = <1>;
			qcom,gmac3_enabled = <1>;
		};

		nss-gmac-common {
			reg = <0x03000000 0x0000FFFF 0x1bb00000 0x0000FFFF 0x00900000 0x00004000>;
			reg-names = "nss_reg_base" , "qsgmii_reg_base", "clk_ctl_base";
		};

		gmac1: ethernet@37000000 {
			device_type = "network";
			compatible = "qcom,nss-gmac";
			reg = <0x37000000 0x200000>;
			interrupts = <GIC_SPI 220 IRQ_TYPE_LEVEL_HIGH>;
			phy-mode = "rgmii";
			qcom,id = <0>;
			qcom,phy_mdio_addr = <4>;
			qcom,poll_required = <1>;
			qcom,rgmii_delay = <1>;
			qcom,emulation = <0>;
			qcom,forced_speed = <1000>;
			qcom,forced_duplex = <1>;
			qcom,socver = <0>;
			local-mac-address = [000000000000];
			mdiobus = <&mdio0>;
			avm,phy_mii_type = <0>;
			avm,dma_mask = <0xffffffff>;
		};
        
        /delete-node/ ethernet@37200000;

		gmac3: ethernet@37400000 {
			device_type = "network";
			compatible = "qcom,nss-gmac";
			reg = <0x37400000 0x200000>;
			interrupts = <GIC_SPI 226 IRQ_TYPE_LEVEL_HIGH>;
			phy-mode = "sgmii";
			qcom,id = <2>;
			qcom,phy_mdio_addr = <0>;
			qcom,poll_required = <0>;
			qcom,rgmii_delay = <0>;
			qcom,emulation = <0>;
			qcom,forced_speed = <1000>;
			qcom,forced_duplex = <1>;
			qcom,socver = <0>;
			local-mac-address = [000000000000];
			mdiobus = <&mdio0>;
			avm,phy_mii_type = <1>;
			avm,dma_mask = <0xffffffff>;
		};
	};
};