/* * Copyright (c) 2022 Project CHIP Authors * All rights reserved. * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ #include "OTAUtil.h" #if CONFIG_CHIP_OTA_REQUESTOR #include #include #include #include #include #include #include #include #endif using namespace chip; using namespace chip::DeviceLayer; #if CONFIG_CHIP_OTA_REQUESTOR namespace { DefaultOTARequestorStorage sOTARequestorStorage; DefaultOTARequestorDriver sOTARequestorDriver; chip::BDXDownloader sBDXDownloader; chip::DefaultOTARequestor sOTARequestor; } // namespace // compile-time factory method OTAImageProcessorImpl & GetOTAImageProcessor() { #if CONFIG_PM_DEVICE && CONFIG_NORDIC_QSPI_NOR static OTAImageProcessorImpl sOTAImageProcessor(&GetFlashHandler()); #else static OTAImageProcessorImpl sOTAImageProcessor; #endif return sOTAImageProcessor; } void InitBasicOTARequestor() { VerifyOrReturn(GetRequestorInstance() == nullptr); OTAImageProcessorImpl & imageProcessor = GetOTAImageProcessor(); imageProcessor.SetOTADownloader(&sBDXDownloader); sBDXDownloader.SetImageProcessorDelegate(&imageProcessor); sOTARequestorStorage.Init(Server::GetInstance().GetPersistentStorage()); sOTARequestor.Init(Server::GetInstance(), sOTARequestorStorage, sOTARequestorDriver, sBDXDownloader); chip::SetRequestorInstance(&sOTARequestor); sOTARequestorDriver.Init(&sOTARequestor, &imageProcessor); imageProcessor.TriggerFlashAction(ExternalFlashManager::Action::SLEEP); } void OtaConfirmNewImage() { #ifndef CONFIG_SOC_SERIES_NRF53X /* Check if the image is run in the REVERT mode and eventually confirm it to prevent reverting on the next boot. On nRF53 target there is not way to verify current swap type because we use permanent swap so we can skip it. */ VerifyOrReturn(mcuboot_swap_type() == BOOT_SWAP_TYPE_REVERT); #endif OTAImageProcessorImpl & imageProcessor = GetOTAImageProcessor(); if (!boot_is_img_confirmed()) { CHIP_ERROR err = System::MapErrorZephyr(boot_write_img_confirmed()); if (CHIP_NO_ERROR == err) { imageProcessor.SetImageConfirmed(); ChipLogProgress(SoftwareUpdate, "New firmware image confirmed"); } else { ChipLogError(SoftwareUpdate, "Failed to confirm firmware image, it will be reverted on the next boot"); } } } #endif ExternalFlashManager & GetFlashHandler() { static ExternalFlashManager sFlashHandler; return sFlashHandler; }